HN8N
2Pages

Catalog excerpts

TECHNICAL SHEET CABLE CUTTER max. diameter 13mm PRODUCER: „HUBIX" CHARACTERISTICS Insulated tool made of CrV. Two layers of insulation, white and orange, at least 1mm + 1mm made of plastisol. Tool has a guard that the hand is prevented from slipping towards the uncovered conductive parts. Tool is controlled and tested (10kV/10s) in accordance with EN 60900:2004 Length: 250 mm. Weight: 470g APPLICATION Live working up to 1000V a.c. and 1500V d.c. Tool is used to cut cables and wires ( Al, Cu max. diameter 13mm) on overhead lines and connecting boxes. STORAGE AND MAINTENANCE Insulated or insulating hand tools should be properly stored to minimize the risk of damage to the insulation due to storage or transportation. These tools should be stored generally separated from other tools to avoid mechanical damage or confusion. Tool should be prevented from excessive heat and sun light. Use a dry tissue to clean. When tool becomes strong soiled use suitable solvent to clean. CHECK AND PERIODIC INSPECTION Before use, each hand tool should be visually inspected by the user. An annual visual examination by a suitably trained person is recommended to determine the suitability of the tool for further service. The visual check shall be considered successful if: o The tool (in particular the insulation) is free from external defect, o The marking is legibly and complete.

Open the catalog to page 1

Don’t use damaged, worn-out (cracks or deep scratches on insulation) or dirty tools in live working. Damage insulation as a result of appearance internal layer (white) eliminates the tool in live working. Tool which becomes wet must be dried before use. ATTENTION! In case of doubt after visual examination, the routine dielectric test should be preformed. FREQUENCY TESTS For check and periodic inspection to be carried out in according to below table. PERIODIC INSPECITON PERIODIC INSPECION CARD supervisor result

Open the catalog to page 2