hotflex®cs Flexible tubular heater with bendable unheated zones

hotset Facts ■ Easy installation with a uniform finish ■ Can be formed by hand ■ Stored in a straight condition to save storage space ■ No special installation tools required ■ Patented technology ensures industry leading heat transfer ■ Up to 75% sheath contact with round and square hotflex heaters when recommended groove geometry is followed ■ Rapid heat-up times ■ Minimal temperature difference between heater sheath and heated tool ■ 3-dimensional groove geometry possible ■ Industry’s smallest bending radius ■ Hotflex’s flexibility enables heat to be located where it is needed; an improvement...

Depending on the number of bends the hotflex length can increase. For a more precise calculation of the extension you might use our template for assistance: www.hotset.com/hotflex_extensionfactors Connector types Recommended groove geometry Type hotflex cs Standard: threaded pins M2.5 Option: M4 from 0 8.0 mm with set of nuts and washers, Temp, resist. 350 °C / 660 °F Ceramic terminal connector “plug ’n’ heat” Temp, resist. 230 °C / 445 °F Short term max. 280 °C / 535 °F 14x21 x25 mm/5.51 x8.27x9.84“ available with stock items Plain Ni-leadswith ceramic beads insulation, upto 600 °C/1110°F Insulated...