video corpo

LV-F series
1 /1Page

LV-F series

LV-F series
1 /1Page

Catalog excerpts

LV-F series-1

LV-F Series Liquid Flow Controller Specification Model Flow Range (g/min) Measurement Range Application Liquid*1 Viscosity*2 Accuracy*3 Linearity Repeatability Response Operating Temperature*5 Temperature coefficiency Operating Pressure*6 Pressure Resistance Pressure Drop*7 Flow Rate Signal 5 to 100% F.S. All liquids except those corrosive to stainless steel (ex, HCl and HF) ± 0.1%F.S./°C max± 1% 0.05 to 0.3 MPa 1MPa Analog: 0 to 5 VDC Digital: RS485 Power Supply Leak Integrity PO Type: Less than 1 to 10-8Pa·m3/s (He) MO Type: Less than 5 to 10-12Pa·m3/s (He) Wetted Material PO Type: SUS316L, Ni, PTFE, PFA MO Type: SUS316L,Ni 1/8" compression 1/4" compression 1/16" , 1/8" compression fitting, 1/8" VCR type fitting 1/8" VCR fitting 1/4" VCR type type Standard Fitting *1 With the LF-F/LV-F Series, flow rate calibration is performed using one specified type of liquid. (Please indicate the type of liquid to be used when ordering the device.) - Liquids containing solid materials cannot be measured. - Please consult us in advance if you plan to use these devices with liquid mixture for which the mixture ratio may vary. - With the LV-F Series, if the liquid to be measured contains particle etc., please install a 0.2 µm (Abs) filter on the primary side. *2 The LV-F Type can be used with a maximum viscosity of 0.01Pa·s depending on the flow rate range. Please consult us in advance if you plan to use this device with high-viscosity liquids. *3 Specification of accuracy, linearity and repeatability is guaranteed against calibrated liquid based on SEMI E561296. *4 It is the specification which is adjusted by Auto-PID function with our piezo control valve. *5 In order to ensure precise measurement, please maintain incoming liquid temperature to be within 10 deg.C lower or 3 deg.C higher than the ambient temperature. *6 Specification of Operating Pressure is the pressure range when liquid viscosity is 0.001Pa·s. *7 Specification of pressure drop is when liquid (with viscosity of 0.001Pa·s) is introduced at 100% F.S. of measurement point. LV-F Series Web Ver.001 Subject to change wi

 Open the catalog to page 1

All HORIBA STEC catalogs and technical brochures

  1. 1000M Series

    2  Pages

  2. ru1000

    4  Pages

  3. HF HD-960L

    5  Pages

  4. CEMS

    4  Pages

  5. HE-960HC

    5  Pages

  6. VULCAN Evo

    4  Pages

  7. MEDAS

    8  Pages

  8. OBS-ONE GS

    6  Pages

  9. Oil analysis

    3  Pages

  10. HORIBA Report

    86  Pages

  11. MI/MV

    1  Page

  12. LF-F series

    1  Page

  13. SEC-Z500MGX

    16  Pages

  14. Vaporizers

    8  Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.