PRODUCT DATA V5832B V5833A GENERAL These small linear valves are used in combination with small electric linear valve actuators for the control of hot and/or chilled water for fan coil units, small reheaters/recoolers in electric/electronic temperature control systems. Because of the pressure-balanced plug, the close-off pressure is equal to the system pressure. FEATURES • Pressure balanced plug • Range of fittings available for different connections • Easy to mount, no tools required • Flat sealing connections • Flat surfaces on body to fit installation tools • Standard external threads for Honeywell or field supplied fittings • Adjustment cap for manual operation Three-way: V5833A Operation Stem up to close port A to AB Nominal pressure rating PN16 Capacity index (kVS) see tables on page 2 Valve body: Material Brass resistant to dezincification Trim: Stem Plug Stainless steel Brass Suitable medium Water, with max. 50% glycol Controlled water temperature: 2...130°C Rangeability Flow characteristic Stroke Dimensions 50:1 Linear for port A-AB, linear for bypass port B-AB 6.5 mm see Fig. 3 on page 4 ® U.S. Registered Trademark Copyright © 2012 Honeywell Inc. • All rights reserved

V5832B/V5833A SMALL LINEAR VALVES PN16 - PRODUCT DATA OPERATION A built-in return spring produces a closing force. The valves are supplied with an adjustment cap for manual operation and to protect the stem. This allows the stem set up for filling or initial heating/cooling during the building construction phase without the use of a controller or actuator. The small electric valve actuators provide automatic control during the opening and closing movement of the valve stem. Three-Way Valves These valves are preferably used as mixing valves, this means: Port AB: Total flow outlet Port A: Controlled...

V5832B/V5833A SMALL LINEAR VALVES PN16 – PRODUCT DATA MOUNTING When installing the valve care must be taken that the flow direction is correct (see section "Typical Operation"). The valve must not be mounted with the stem pointing downward. The adjustment cap must be removed from the valve only when the actuator is fitted. The valve should be installed as stress-free as possible with a tightening torque of 25 to 30 Nm. The valve is supplied complete with mounting instructions. The water quality should meet VDI 2035 requirements. ACCESSORIES Valves V5832B need two connection sets, valves V5833A...

V5832B/V5833A SMALL LINEAR VALVES PN16 - PRODUCT DATA Manufactured for and on behalf of the Environmental and Combustion Controls Division of Honeywell Technologies Sari, Rolle, Z.A. La Piece 16, Switzerland by its Authorized Representative: Automation and Control Solutions Honeywell GmbH Boblinger Strasse 17 71101 Schonaich, Germany Phone: (49) 7031 63701 http://ecc.emea.honeywell.com Subject to change without notice. Printed in Germany