V5822A / 5823A,C
6Pages

V5822A / 5823A,C SMALL LINEAR VALVES PN16 FOR MODULATING AND ON/OFF-CONTROL SPECIFICATION DATA GENERAL These small linear valves are used in combination with small electric linear valve actuators and thermoelectric actuators for the control of hot and/or chilled water for fan coil units and small reheaters/recoolers in electric/electronic temperature control systems. FEATURES • Small size allows installation where space is limited. • Range of fittings available for different connections (compression, soldered, threaded). • Long stroke results in a high-quality characteristic. • Soft seat provides low leakage rate and high rangeability. • Reduced kVS values in the bypass to facilitate hydronic balancing. • Adjustment cap for manual operation. • Valve inserts changeable without draining by using insert replacement tool WV108M. • Compatible with 2-piece conex compression fittings. • Conical sealing connections. • Flat surfaces on body to fit installation tools. • 40 mm distance between ports A/AB and the bypass Three-way V5823A Three-way with bypass V5823C Operation Two-way stem up to open, port A to B; Three-way stem up to close, port A to AB Nominal pressure rating PN16 Capacity index (kVS) see tables on page 2 and 3 ® U.S. Registered Trademark Copyright © 2018 Honeywell Inc. • All rights reserved Valve body Material Brass Trim Stem Stainless steel Plug Brass Suitable medium Water, with max. 50% glycol Controlled water temperature 2...120 °C

V5822A / V5823A,C SMALL LINEAR VALVES PN16 - SPECIFICATION DATA Modulating valves Rangeability Two-way valves100:1 Three-way valves Flow characteristic Stroke On/Off valves Stroke Dimensions 100:1 for controlled port Equal percentage port A-AB, ngl=3.4, linear for bypass port B-AB 6.5 mm 2.5 mm see Fig. 4 on page 5 FLOW CAPACITIES AND CLOSE OFF PRESSURE RATINGSTWO-WAY VALVES Valve *Up to 1000kPa system pressure. **In the case of on/off control, the stroke amounts to 2.5 mm. *In the case of on/off control, the stroke amounts to 2.5 mm.

V5822A / V5823A,C SMALL LINEAR VALVES PN16 - SPECIFICATION DATA *In the case of on/off control, the stroke amounts to 2.5 mm. OPERATION A built-in return spring in the two-way valve produces an opening force. In the three-way valve and the three-way valve with bypass, the spring produces a closing force on the A to AB ports. The valves are supplied with a screwed-on adjustment cap for manual operation and for protection of the stem. This allows the stem to be set up for filling or initial heating / cooling during the building construction phase without the use of a controller or actuator....

MOUNTING When installing the valve, care must be taken that the flow direction is correct (see section "Typical Operation"). The valve must not be mounted with the stem pointing downward. The adjustment cap must be removed from the valve only when the actuator is fitted. The valve should be installed as stress-free as possible with a tightening torque of 25 to 30 Nm. The valve is supplied complete with mounting instructions. The water quality must meet VDI 2035 requirements. ACCESSORIES For valves V5822A, two connection sets are necessary; for valves V5823A, three connection sets are...

V5822A / V5823A,C SMALL LINEAR VALVES PN16 - SPECIFICATION DATA Two-way valve Three-way valve Three-way valve with bypass *Modulating valves, only (in the case of on/off valves, the stroke amounts to 2.5 mm and the closure distance to 14 mm).

V5822A / V5823A,C SMALL LINEAR VALVES PN16 - SPECIFICATION DATA Valve inserts are provided as spare parts for the V5822A and V5823A,C small linear valves. When the tool WV108M is used, the valve inserts can be changed without draining the system. The following valve inserts are interchangeable • Two-way valves: kVS 0.16, 0.25, 0.40, and 0.63 Manufactured for and on behalf of the Environmental & Energy Solutions Division of Honeywell Technologies Sari, Rolle, Z.A. La Piece 16, Switzerland by its Authorized Representative: Home and Building Technologies Honeywell GmbH Boblinger Strasse 17...