Perfecting Measurement™ Grooved Turbine Flowmeters TECHNICAL DATA SHEET FOR COMPLETE MODEL NUMBER INFORMATION, PLEASE SEE REVERSE. Flow Range (Note 1) Ranges shown are standard ranges — other ranges are available. Contact Hoffer Flow Controls Applications Group. Bearing Selection: Hybrid Ceramic, Self-lubricating shielded ball bearings must be used on C02, may be used on H20 and never on H20/Sand or CS. Hard Carbon Composite Sleeve bearings. For use on H20 only. Tungsten Carbide Sleeve bearings must be used on H207Sand and CS, may be used on H20 and never used on C02. Please Note: Flowmeter service life is reduced when flows contain particulate. GENERAL SPECIFICATIONS Linearity: ±0.5% of reading (±0.25% typical) Pressure Drop over tabulated linear flow range. Characteristics: Repeatability: ± 0.1 % over tabulated useable range. Overrange: Temperature Range: -450°F to + 450°F (Standard). Construction: Request graphical data. 150% of maximum flow (intermittently). Flowmeters are calibrated and supplied with "K" Factor Tag. ®Vlctaullc Is a registered trademark of Vlctaullc Company of America.

GROOVED TURBINE FLOWMETER MODEL NUMBERING SYSTEM MODEL HO ( A ) X ( B ) - ( C ) - ( D ) - ( E ) - ( F /G/ H ) - ( I ) - ( J ) - A. End Fitting Size B. Flowmeter Size C. Minimum Operating Flow D. Maximum Operating Flow E. Bearing Type (BP) (CB) (C) (T) Self-Lubricating, Ceramic Hybrid Ball Bearing for 1” and smaller. Self-Lubricating, Ceramic Hybrid Ball Bearing for 1-1/2” and larger. Hard Carbon Composite Sleeve Bearing Tungsten Carbide Sleeve Bearing F. Pickup Coils (1M) (2M) (1MC3PA) (2MC3PA) (1MC2PAHT) (2MC2PAHT) (1HTM) (2HTM) (1ISM) (1ISM-ATEX) (2ISM) (2ISM-ATEX) _(RP___) _(_____) (P) One...