TECHNICAL SPECIFICATIONS SERIES Floor stand version Options Adapters Spart parts kit Consumable kit Sample preparation device Floor stand Desktop version Optical system Typical applications • LightWing technology: Multi-CMOS optics in Paschen-Runge mounting and optimized pixel resolution • Quality control for process and melt verification: analysis mode / grade identification • All relevant alloying, residual, treatment, trace and tramp elements with low limits of detection • Wave length: OE720: 174 - 670* nm / OE750: 119 - 670* nm (*766 nm on request) • Peak position alignment • Fe: Alloys, cast iron alloys incl. N down to 10 ppm (OE750 only) • Al: Alloys, cast alloys, wrought alloys… • Cu: Bronze, Brass, Cu-Ni… Argon supply • Ni: hasteloy, inconel, monel, incl. N down to 20 ppm • Ti: Ti pure, Ti.6-4, Ti.8-Mn, incl. gases such as H, O, N (OE750 only) • Mg, Co, Pb, Sn, Zn alloys, solders and more 5.0, if analysis of gases is required (OE750 only) Solid state source Power supply • 100 - 240V AC 50/60 Hz • ower consumption max: 430 W P • Standby mode 45 W (50 W source on) Readout system • External PC-Workstation incorporating up-to-date technology with Microsoft® Windows® user interface • Computer controlled parameters • Frequency: 80 - 1000 Hz • Voltage: 250 - 500 V • High energy pre spark (HEPS) Environmental data • Temperature range Storage: -10° to +60°C In operation: 0° to

Visit www.hitachi-hightech.com/hha for more information. This publication is the copyright of Hitachi High-Tech Analytical Science and provides outline information only, which (unless agreed by the company in writing) may not be used, applied or reproduced for any purpose or form part of any order or contract or regarded as the representation relating to the products or services concerned. Hitachi High-Tech Analytical Science’s policy is one of continued improvement. The company reserves the right to alter, without notice the specification, design or conditions of supply of any product or service....