Catalogs >
HIOKI E.E. CORPORATION >
HIOKI 3331 and 3332 Power HiTESTER

HIOKI 3331 and 3332 Power HiTESTER
8Pages

Catalog excerpts

2 Basic Performance of the 3331/3332 □ Evaluation of electric equipment such as inverters High basic accuracy of ±0.2% More prթcise measurement non possible with a basic accuracy of ±0.1% rdg.±0.1% f.s. Responsitivity that follows transient power fluctuations A achieve responses under 0.3 seconds for measurements of transient power fluctuations (Response speed set at FAST). Օ Simultaneous integration of current and power at a 6-digit high-resolution state A maximum of ±999999 (MWh or MAh) or up to a maximum of 10000 hours (416 days) of integration. Broadband feature compatible with...

Open the catalog to page 3

3 From minute standby power to rush current for motors Applications that efficiently evaluate electrical equipment □ Common features of the 3331 and 3332 Measurement of rush current during device start-up Measurement of the current waveform wave peak is possible, and if the peak hold function is used, wave peak detection of the motor rush current waveform (Max. 90A) and the maximum value of the effective value can be done. RMS response approx. 0.2 sec. HIOKI 3331 POWER HiTESTER Օ Measurement of the RMS value for industrial frequency components. The average rectified effective value...

Open the catalog to page 4

4 Application example using the GP-IB/RS-232C interface The 3331 and 3332 are equipped with the GP-IB and RS-232C interfaces as standard features, allowing complte control from a computer (except for turning the power supply ON/OFF). In addition, measurement data can be directly downloaded into commercially available spreadsheet software on a computer using application software, making the troublesome creation of test result charts easy, and supporting effective data management. ration with EXCEL* *EXCEL is a registered trademark of Microsoft Corporation. »».n.--- saaaaaa?ll ^aaaaaa軮ii...

Open the catalog to page 5

5 Phase diffrence between voltage and current/Correlation function with other parameters Fluctuation state analyzed in clear waveforms. □ Application example of monitor, analog, and D/A output The 3331 and 3332 are capable of simultaneous output of voltage and current waveforms as well as the active power level, and when connected to a HIOKI MEMORY HiCORDER or Hybrid Recorder, events ranging from long-term fluctuations to transient phenomena (only with MEMORY HiCORDERs) can be recorded. Select one other measurement item (apparent power/reactive power/power factor/integration power...

Open the catalog to page 6

6 □ Basic specification Measurement line : 3332: single-phase, 2-wire 3331 : single-phase, 3-wire; 3-phase, 3-wire; single-phase, 2-wire (channel ranges cannot be independently set) : Voltage, current, current peak, active power, apparent power, reactive power, power factor, phase angle, frequency, power integration, current integration : 0.1% to 130% of range (zero-suppressed for less than 0.1%) (3332; zero-suppressed for less than 0.2% of V range and 40pA) 3332: Voltage, current, power; Effective input range : 5% to 120% of measurement range (5% to 100% of 600V range only) 3331: Voltage,...

Open the catalog to page 7

7 □Related products ■ Basic specification Measurement line Measurement item : Single-phase, 2-wire; single-phase, 3-wire, 3-phase, 3-wire; 3-phase, 4-wire : [When used with 9600, 9601, 9602 (option)] voltage, current, voltage and current waveform peak, active/ reactive/apparent power, power factor, phase angle, frequency, current and power integration; load factor; efficiency [When 9603 is used (option/above functions plus functions written below)] voltage, torque, rotation count, frequency, motor output [When 9605 is used (option/ail functions above plus functions written below)]...

Open the catalog to page 8

HIOKI 3331 and 3332 Power HiTESTER 8Pages

Catalog excerpts

All HIOKI E.E. CORPORATION catalogs and technical brochures

HIOKI 3331 and 3332 Power HiTESTER
8Pages