Section vii: Handheld and stand-mounted drills (including impact and rotary hammer drills) Current Hilti rotary hammers that use a DRS-S shroud TE 2 (and 2-S)

These systems fall under table 1, section vii: handheld and stand-mounted drills (including impact and rotary hammer drills). In order to be table 1 compliant, the below requirements must be met: • Use drill equipped with commercially available shroud or cowling with dust collection system • Operate and maintain tool in accordance with manufacturers instructions to minimize dust emissions • Dust collector must provide the air flow recommended by the tool manufacturer, or greater • Have a filter with 99% or greater efficiency and a filter-cleaning mechanism Note: Vacuum must be equipped with a...

DRS-S Submittal SYSTEM OVERVIEW Hilti rotary hammers with a DRS-S are table 1 compliant through use of a dust collection shroud hooked up to a vacuum that meets table 1 requirements. This shroud attaches to the depth gauge on the tool, and must be purchased separately for tools with an SDS-max connection. Any Hilti rotary hammer with a depth gauge will be table 1 compliant with the DRS-S if a Hilti vacuum is used. Hilti currently offers the below systems with this configuration: Tool Note: previous generations of tools may have different item numbers or nomenclature. Check with your local Hilti...

Depth gauge (sold separately) Note: previous generations of tools may have different item numbers or nomenclature. Check with your local Hilti representative or product instruction manual to verify

DRS-S Submittal Hilti developed drilling dust collection systems with a shroud, to be attached to a Hilti vacuum with a filter cleaning mechanism and 99% filter efficiency, compliant with OSHA 1926.1153, Table 1. 1. Attach the appropriate dust collection shroud to the drill. 2. Insert the bit. Rotate the bit in the chuck until you hear a clicking noise to verify that the bit is firmly inserted into the chuck. 3. Choose the correct collector based on the system and insert being used. 4. Set the proper depth using the depth gauge mechanism on the shroud. This will either be a depth gauge rod (DRS-Y,...