DIL-32 Communication-IC with Modbus Host Interface → Compact communication module for cost-efficient field devices → Fieldbus and Real-Time Ethernet as Slave → Modbus RTU protocol via SPI or UART to the host → One hardware for all Real-Time Ethernet protocols Real-Time Ethernet → Firmware update via integrated Webserver → One design for all networks due to consistent interfaces Fieldbus Slave solution for simple field devices Simple field devices such as barcode readers, identification systems, valve islands or I/O blocks will require a connection to Fieldbus or Real-Time Ethernet systems. Since these devices do not have a high data throughput, the netIC uses a serial connection such as UART and SPI as host interface. The netIC is a complete ‘Single Chip Module’ in the compact dimensions of a Dual-In-Line (DIL) 32 pin plugin module. It is based on the network controller netX and contains all components of a Fieldbus or Real-Time Ethernet interface with integrated 2-port switch and hub. → netIC Service hotline: +49 (0) 6190 9907-90 www.hilscher.com With the netX technology the whole spectrum of relevant Fieldbus and Real-Time Ethernet systems is covered by loadable firmware with one netIC. The user data is transferred with simple read-write commands to the application via the above mentioned serial interfaces. As serial protocol the well known Modbus RTU protocol is used. Alternatively conventional shifting registers can be controlled via a synchronous serial interface so no additional processor for a simple I/O-Devi

netIC DIL-32 Communication-IC with Modbus Host Interface Core Technology Direct I/O data transfer The Hilscher Platform Strategy provides the whole range of communication solutions to the user – from standardized PC cards up to the integration of the multi-protocol chip netX. All solutions – whether Master or Slave – have the same interface to the application and use the same tools. netIC allows the direct connection of I/O data via conventional shift registers. This is beneficial for compact and simple field devices, since a product design can be realized without a host processor. The shifting...

Technical Data Technical Data Technical Data Operating Temperature Processor Operating Voltage Certification +3.3 V / typ 400 mA CE Sign, RoHS, UKCA Dimensions without Pins | with Pins (L x W x H) Diagnosis Communication Interface 2x Ethernet 100 BASE-TX CANopen / DeviceNet / PROFIBUS SSIO Interface Inputs max. 256 x 8 bit shift register Outputs max. 256 x 8 bit shift register System LED (on netIC), COM LED (on basic design) System Interface Modbus RTU via UART (Master/Slave) max. 115.2 KBit/s Modbus RTU via SPI (Slave) max. 102 KBit/s Note: All technical data may be changed without further notice....