Catalogs >
The Hilliard Corporation >
Hil-fl o? Oil Filters for up to 150 PSI and 25 GPM Service

Hil-fl o? Oil Filters for up to 150 PSI and 25 GPM Service
2Pages

Catalog excerpts

Hil-fl o? Oil Filters for up to 150 PSI and 25 GPM Service - 1

PRODUCT INFORMATION Hil-o™ Oil Filters for up to 150 PSI and 25 GPM Service Hilco’s Hil-o™ 01HMF-0150 Series lter vessels permit full-ow or off-line ltration of uids at working pressures to 150 PSI and ow rates to 25 GPM. Inexpensive and compact, the versatile 01HMF-0150 lters utilize Hilco o-ring sealed cartridges which feature large dirt-holding capacities for efcient, costeffective ltration of hydrocarbon oils, synthetic lubricants, and solvents used as fuel, lube, seal, hydraulic, heat transfer, and insulating oils. Hil-o lters feature a newly designed cover and an “O” ring which enhance the lter’s sealing capabilities. The Hil-o 01HMF-150 Series lters are available in two models, featuring one or two cartridges. Hydraulic Systems Diesel and Gas Engines Turbines Machine Tools Compressors and Vacuum Pumps Features: • All-steel welded construction • Newly designed cover and Buna-N “O” ring gasket for better sealing • Swing bolt cover; no loose hardware • Accept Hilco’s o-ring sealed pleated paper, PH, stackeddisc and fuller’s earth or activated alumina-lled cartridges for various ltration applications, dirt-holding capacities and ltration efciencies • Filtration efciencies from Beta5 = 75 to Beta58 = 75 (nominal 0.5 to 10 microns) • Holds one or two cartridges • 1” FPT accessory connections • Positive hold down cap How to Read Filter Model Numbers Options: • • • • • • Pressure Gauge(s) Vent Valve Relief Valve Drain Valve Viton “O” Ring Gasket Reusable adapter to accommodate cartridges without centertubes • Piping package for multiple vessels (series or parallel connections) Standard construction Maximum design pressure (psi) Number of cartridges per Benets: • Provides efcient ltration of uids used in contaminant-sen- centerpost Design revision sitive systems designation • Uses entire range of Hilco lter cartridges for removal of Total number of particulates, acids, water, varnishes, tars, lacquers, and cartridges gums • Economically priced • Easy to service • “O” ring cover seal © Copyright 1984, by The Hilliard Corporation. All rights reserved. Hil-o is a trademark of The Hilliard Corporation.

Open the catalog to page 1

Hil-fl o? Oil Filters for up to 150 PSI and 25 GPM Service - 2

Filter Models Max. Flow Rate-GPM (LPM)* 3 PSID @ 200 SUS Pleated Paper DirtHolding Capacity (Grams)* C Headroom Required For Cartridge Removal In. (mm) * Dependent upon cartridge model used. ** 36” (914mm) for single elements. NOTE: Maximum Temperature 250º F (121º C) The Hilliard Corporation reserves the right to change dimensions and specications at any time. Please contact the factory for the most current information. The Hilliard Corporation 100 West Fourth Street Elmira, New York 14902-1504 Phone: 607-733-7121 Fax: 607-733-0928 http://www.hilliardcorp.com HLI-2 Your Local Representative:

Open the catalog to page 2