TRCF-0500-060606 Temperature regulated curing furnace
3Pages

Rev. 1.0 09-May-2023 TRCF-0500-060606 Temperature regulated curing furnace Product Datasheet General information: Furnace for heat treatment of parts during strain gages bonding, as well as other heat treatment works. The furnace has a temperature controller to regulate the temperature in the furnace chamber in accordance with the heat treatment programs for various adhesives and cements used in strain measurement of parts and assemblies. The use of preset programs ensures that the entire heat treatment cycle is carried out in automatic mode and eliminates possible errors associated with incorrectly setting the temperature and/or the time of temperature set-up or holding on the “shelf” by the user, and also frees the user from the need to reconfigure the controller to proceed to the next heat treatment step. An example of a heat treatment program for NCC-3 cement, consisting of three steps

A set of programs (up to 20 programs) is set during the manufacture of the furnace in accordance with the needs of the Customer. In addition, there is a “Manual” mode, in which the user can independently set an arbitrary heat treatment program containing from 1 to 3 steps, for each step the following is set: temperature, temperature rise time and holding time at a given temperature. Additionally, the furnace, when executing the program, registers the values of the actual and calculated temperature in accordance with the heat treatment program being executed with a period of 1 to 5 minutes,...

Examples of heat treatment programs A specific set of programs is installed at the request of the Customer Heat treated material Adhesive GD-711, variant 2, step 1 Adhesive GD-711, variant 2, step 2 Ceramic cement HG-1, step 1 Ceramic cement HG-1, step 2 Ceramic cement HG-1, step 3 Ceramic cement NCC-3, step 1 Ceramic cement NCC-3, step 2 Ceramic cement NCC-3, step 3 Drying after sandblasting