NETWORKED ACCESS SOLUTIONS VertX™ V200 Input Monitor Interface ALARM INPUT PROCESSING FOR UP TO 16 ZONES • 70200 Reports supervised or unsupervised alarm circuits. Off-normal condition programmable for each input point (NO or NC alarm devices may be used). Receives and processes real-time commands from the V1000. Enables complex input/output linking when used with the V1000 and V300 Output Control Interface. Attractive polycarbonate enclosure protects components from damage. All connections and indicators are fully identified by silk-screened nomenclature on the cover. The HID VertX™ products provide a complete and fully featured hardware/firmware infrastructure for access control software host systems. The V200 input monitor interface connects up to 16 supervised input circuits. Each input point monitors and reports normal, offnormal, and alarm states. The V200 features on-board flash memory, enabling program updates to be downloaded through the network. The V200 connects to the V1000 via a high-speed RS-485 network. The V1000, in turn, communicates with the system host via industry standard TCP/IP protocol, over 10/100 Mbps Ethernet, or the Internet. This architecture minimizes the impact on corporate LANs, by using only one TCP/IP address for every 32 interfaces, and by handling low-level transactions on the RS-485 network.

EASILY INTERFACED LOCAL PROCESSING Mount to any wall surface, using four screws. For UL® compliance, one or more interfaces can be mounted inside a locking customersupplied NEMA-4 rated enclosure with: Quick-disconnect screw terminal connectors Alarm shunt and strike relay timing and latching functions Rotary address switch (0–15) Access control decisions based on facility code (degraded mode) Basic input/output linking • Battery Fail Monitor* LED/beeper control during card + PIN, scheduled unlock, and other transactions • Enclosure Tamper* DC supply with battery back-up Enclosure tamper switch...