Datalogger Sonar Sensors HZ-FA-100 HZ-FA-100C HZ-FA-100R HZ-FA-100/100C/100R is the datalogger/sensor of the air sonar system. User can choose from the Remote Acoustic Sensor FA-100R which measure the target from distance, or the Conducting Acoustic Sensor FA-100C which is mounted on the target, to couple with the datalogger FA-100. This system supports two channels high-speed data acquisition of signals. TCP/IP communication protocol is used to couple with Hertzinno Software SDK or other third-party software platforms to realize the function of sound characteristics detection in specific scenarios. Key Feature • Dual-channel synchronous acquisition, supporting up to 125kHz sampling rate • Supports Ethernet communication, RJ45 data interface, easy to access the network • 25°C~ + 55°C Working temperature, strong environmental adaptability • IP67 Waterproof • Compact size; easy to install and carry. • Low Power consumption, suitable for scenarios with low power consumption requirements • Overvoltage, overcurrent and anti-reverse connection protection functions

ill HERTZlNND ■I1 HZ-FA-100/100C/100R DV 12V Ethernet -20°C ~ 50 °C IP65 Supported Supported Supported Model Industrial Power Source Data Interface Working Temperature Range Ingress Level Overvoltage Protection Overcurrent Protection Anti-reverse connection Protection Microphone SNR Freq Response Sensitivity Direction General Product Size Product Weight Sensor Qty Sensor Type Sampling Mode Sampling Frequency ADC 110mm*64mm*38mm (data logger) 200g 2 External Sensors Synchronized Acquisition 125kHz 24 bit

◼ Installation System Connection Target Under Test Sonar Sensor Data Logger Switch Board Data Logger Installation There are four 3mm threaded mounting holes on the back of the Data Logger. During actual installation, it can be fixed wall-mounted or pole-mounted.

Sensor Installation Acoustic sensor installation currently supports three installation methods: magnetic installation, adhesive installation, and screw mounting installation. • Magnetic installation - there is a magnet fixed at the bottom of the acoustic sensor, which can be directly sticked on the surface of the iron shell. During installation, the mounting surface must be flat to ensure the installation. • Adhesive installation - before installation, user needs to select a flat location, clean the dust, debris, etc. on the mounting surface, and then apply the adhesive 3M double sided sticky...