Ammunition Primer Sealant 59621


Catalog excerpts

Ammunition Primer Sealant 59621 - 1

High Performance Adhesives and Sealants Technical Data Sheet December 2009 Ammunition Primer Sealant 59621 Typical Properties Product Description Hernon® Ammunition Primer Sealant 59621 is a single component U.V. anaerobic sealant. Ammunition Primer Sealant 59621 is a low viscosity penetrating material for bonding and sealing primer in ammunitions. It is specially formulated for pre-assembled components; it works by capillary action and it simplifies preventive maintenance. Curing occurs when adhesive is confined between mating surfaces. The cured adhesive is a thermoset plastic suitable for temperatures up to 400°F (204°C), and exposure to most solvents. Ammunition Primer Sealant 59621 cures quickly at room temperature without the need for surface activators or heat to seal, mark and identify primer assemblies. Fixturing strength develops in two to three minutes, or within 10 seconds by exposing the edge fillets to high intensity long wavelength UV light (365 nm). Full strength will be reached in 24 hours. Cure fillets at UV light irradiances above 60 milliwatts/cm2 to insure proper cure. Product Benefits • UV fluorescence for in-process inspection • 100% solid system (no solvents). • Excellent environmental resistance • Good gap filling properties. • No shrinkage due to solvent evaporation • Rapid room temperature cure • UV and anaerobic curing mechanism • Excellent capillary performance. • Color identification General Information This product is not recommended for use in pure oxygen and/or oxygen rich systems and should not be selected as a sealant for chlorine or other strong oxidizing materials. For safe handling information on this product, consult the Material Safety Data Sheet (MSDS). Where aqueous washing systems are used to clean the surfaces before bonding, it is important to check for compatibility of the washing solution with the adhesive. In some cases these aqueous washes can affect the cue and performance of the adhesive. This product is not normally recommended for use on plastics (particularly thermoplastic materials where stress cracking of the plastic could result). It is recommended to confirm compatibility of the product with such substrates. Directions For Use Shake well before use. For best performance surfaces should be clean and free of grease. Ammunition Primer Sealant 59621 should be applied in sufficient quantity to fill all primer sealant cavities. Disassembly and Cleanup Non-cured sealant can be removed with Hernon® EF® Cleaner 62. Storage Ammunition Primer Sealant 59621 should be stored in a cool, dry location in unopened containers at a temperature between 46°F to 82°F (8°C to 28°C) unless otherwise labeled. Optimal storage is at the lower half of this temperature range. To prevent contamination of unused material, do not return any material to its original container. Dispensing Equipment Hernon offers a complete line of semi and fully automated dispensing equipment. Contact Hernon® Sales for additional information. These suggestions and data are based on information we believe to be reliable and accurate, but no guarantee of their accuracy is made. HERNON MANUFACTURING, INC. shall not be liable for any damage, loss or injury, direct or consequential arising out of the use or the inability to use the product. In every case, we urge and recommend that purchasers, before using any product in full scale production, make their own tests to determine whether the product is of satisfactory quality and suitability for their operations, and the user assumes all risk and liability whatsoever, in connection therewith. Hernon’s Quality Mangement System for the design and manufacture of high performance adhesives and sealants is registered to the ISO 9001 Quality Stan

Open the catalog to page 1

All Hernon Manufacturing catalogs and technical brochures

  1. ReAct 730

    2 Pages

  2. ReAct 727

    3 Pages

  3. HASA 723

    2 Pages