WATERCLEANING FOR DRESTER GUN CLEANERS BY HEDSON A simple and cost effective water cleaning method of dirty water from gun cleaners. The result will be a purified water without environmental impact. The cleaning method used in Drester gun cleaners is very environmentally friendly. The spray gun is easily washed with water or Drester AquaSolve. Since the machines have a closed watersystem, the water consumption per washed spray gun is very low, only 16,9-33,8 oz (0,5-1 L) water / washed gun. The paint and dirt found on and in the spray gun is collected in the wash water, which is then cleaned in the gun cleaner’s built-in water purification system. With Drester watercleaning method, the wash water is easily and efficiently cleaned from all kinds of particles and color, by flocculation and filtration. By adding flocculation powder to the dirty wash water, the paint and dirt residues cling together, and is then easily filtered out. When the paint and dirt remains collected in the filter, allow it to dry, and then easily wipe out the dirt residue and the filter can be reused. To clean the water as efficiently as possible, use dual filters, with different densities and cleaning properties. The entire cleaning process is done in the Drester gun cleaner, takes only 5 minutes and saves a lot of time and money. After cleaning the water, it can be reused for washing or in many cases released into the drain. The rules for sewage differ from municipality to municipality, depending on the type of water treatment methods used by the municipality. To ensure that the purified water is released into the drain, a water sample is taken, which is sent to the municipality’s analysis. If you do not have to let the water in the drain, you will use it again for washing. It is an easy way to wash spray guns and take care of waste water in an environmentally friendly manner

WATERCLEANING Drester by Hedson has developed an advanced flocculation powder that binds paint and dirt particles and thereby separates the waste from the water. Then this can easily be filtered from the water. The various steps for cleaning the water are as follows: Color that is separated by flocking. Start the gun cleaner’s built-in mixer or air activator. Add five mea- sures (0,39 lb/175 g) flocculation powder (art.no. R9211) in the dirty water 1183,4 oz (35 liters). After about 3 minutes of stirring, the mixer should rest for about 1 minute, then started again for an additional 3 minutes....