This data sheet interacts with No. 7 Fixed Centre Carriage with Clamping Brake The HepcoMotion® Fixed Centre Carriage with Clamping Brake provides a safe and simple method of locking the carriage in position to facilitate processes where a secure, stationary platform is required. The brake is intended for manual locking of a stationary carriage and is available in sizes 25, 44 and 76. The brake contains two opposing jaws which when tightened via the ratchet locking lever, secures the carriage in place. Unlike some other systems the resulting clamping force does not load the bearings or deflect the carriage even when a high force is applied. Due to the position of the brake on the carriage, it is not possible to traverse from a ring segment to a straight slide, therefore these carriages are not suitable for use with track systems and can only be used on ring slides and segments. Fixed Centre Carriage 2 x Location dowel holes 4 x Customer fixing holes Ring Slide or Segment Optional Lubricators Clamping Jaws Closed Jaws - Brake Applied Ratchet Locking Lever (variable position) Open Jaws - Brake Released

No.7 Fixed Centre Carriage with Clamping Brake Data & Dimensions A standard range of carriages are available from stock with right handed brakes as shown below. Left handed versions are available to order 4. The position of the ratchet locking lever is reversible so that they can be fitted on the inside of the ring or segment if required. 4 x customer fixing holes - V C C2 4 - Blanking plugs (supplied) 4 - Blanking plugs (supplied) SxT

No.7 Fixed Centre Carriage with Clamping Brake Data & Dimensions (depth) (width) Fixed centre carriages with clamping brakes are not available for rings and segments smaller than R25-255. Offset holes in carriage for eccentric bearings necessitate adjustment rotation in the direction shown. Dimension Y2 is with the locking lever in the disengaged position. Dowel holes V1 are not included as standard on the corrosion resistant version, but are available on special request.

No.7 Fixed Centre Carriage with Clamping Brake Data & Dimensions - Optional Left Handed version A2 A 2 - V1*4 Not on CR version 4 x customer fixing holes - V Left handed versions of the fixed centre carriage are available to order. Other than the position of the brake the general layout and dimensions are the same as the right handed versions, dimensions can be found in the table on 3. CR = Corrosion Resistant Option Leave blank if not required Part Number LH = Left Handed version Leave blank if Right handed version is required LB*1 = Lubricator option Leave blank if not required Bearing Type...