Catalogs >
HepcoMotion >
PRT2 No. 4 Single Edge Track Systems

PRT2 No. 4 Single Edge Track Systems
1 / 4Pages

Catalog excerpts

PRT2 No. 4 Single Edge Track Systems - 1

Precision Ring and Track System This data sheet interacts with PRT2 Catalogue 45-46 No. 4 Single Edge Track Systems Track system single edge slides and segments can be used to construct a single edge track system which provides a wide platform for the rigid support of large components. The large rear face of the single edge slide enables a full width rack to be accommodated, providing for a strong drive. This can be used for the construction of a gear driven duplex track system. This data sheet is intended as a guide to single edge track systems but it is recommended to discuss your application with Hepco’s Technical Department in the first instance. Single edge track system Track system single edge curved segments Track system single edge straight slides Gear driven single edge slide track system Single edge track system with a gear drive on the inner curved and straight slides, engages with a pinion driven from the motor. A sprung pivot arm ensures that the pinion remains engaged with the rack as it travels from straight to curve

Open the catalog to page 1

PRT2 No. 4 Single Edge Track Systems - 2

No. 4 Single Edge Track Systems Single edge track systems are designed to suit individual requirements. They are made up of track system single edge straight slides and track system single edge curved segments. More details of these components can be found on pages 45-46 of the main PRT2 catalogue. It is recommended that they are supplied with a base plate to ensuring correct alignment of the slide to the ring segments, the examples below are shown with base plates, these can be supplied by Hepco, please discuss at the time of ordering. Single edge track systems can also be rack driven as...

Open the catalog to page 2

PRT2 No. 4 Single Edge Track Systems - 3

No. 4 Single Edge Track Systems Below are shown the two standard track configurations available, oval and rectangular, and the relevant dimensions to help with selection. There are two sizes of each configuration available, a small version which uses TNSE track system slides combined with TRIS 278 & TRES 376 segments and a large size which uses TNME single edge slides combined with TRIM 482 & TREM 655 segments. L*1 C*1 Ring Size TRIS 278 For use with slide size TNSE For use with bearing size ...J25... Ring Size TRIS 278 For use with slide size TNSE For use with bearing size ...J25... *1...

Open the catalog to page 3

PRT2 No. 4 Single Edge Track Systems - 4

No. 4 Single Edge Track Systems The carriage plates shown in the data sheet are of a relatively simple design, carriage plates can be customised to suit individual requirements and can be designed to accommodate motors and pinions if a drive is required, please discuss with Hepco’s technical department when ordering the track system. The image below shows how the basic carriage will be constructed with the two eccentric bearings on the outer edge of the carriage plate and thus the outer edge of the track system and the concentric bearings on the inner edge. A Eccentric Bearings Dimensions...

Open the catalog to page 4