N021: Trimble Lassen SK2 clone, with GPS enhanced performance The specifications in this document are subject to change without Notice. Heol Design is not responsible for the operation or failure of operation of GPS satellites or the availability of GPS satellite signals. 1 Bd d’Armor – 22300 LANNION - FRANCE Call: +33 (0)296 484 605 – Fax: +33 (0)296 484 463 E-mail: [email protected] Copyright 2013 All Rights Reserved

HEOL DESIGN has produced a new GPS receiver board, the N021, which is based on the Trimble Copernicus II high performance GPS chip set. This OEM board is designed for use in embedded and industrial applications requiring high accuracy positioning and timing information. It can also be used as a replacement and upgrade for users of the Trimble Lassen SKII receiver board, as an ARM7 microcontroller has been added to adapt exactly to Lassen SK2 protocol and port configuration. ADVANTAGES: Ultra-high sensitivity of -160dBm, enabling high performance acquisition and tracking in urban canyon and signal...

Electrical characteristics: Prime power 5V option Power consumption 5V option Power consumption Backup power Antenna voltage EMC compatibility The N021 board has successfully completed compliance testing against the directive). following standards listed below: (In accordance with the EN55022 class B (conducted and radiated emissions) dated January 1999, with 10dB margin. EN61000-4-3 published in 2002: “Immunity tests on electromagnetic fields radiated at radio-electrical frequencies”, with 10V/m electromagnetic field. EN61000-4-6 published in February 1997: “Immunity tests on conducted interference,...

Mechanical characteristics: Antenna connector heigth = BOTTOM SIDE HEOL DESIGN 1 Bd d'Armor - 22300 LANNION - FRANCE E-mail: [email protected] Copyright 2013 All Rights Reserved

Connectors description 8 pin 2.54mm male header: HEOL DESIGN can provide mother board in metal housing (with protected RS232/RS422 interface and power supply) for your applications upon request. Antenna: Right angle SMB connector (factory configuration). Optional Fakra (automotive compliant), SMA and MCX connector is available upon request. Note: the 10 pins of the programming connector can be cut if necessary (when power is OFF). Factory settings of the serial ports The two communication ports (5V TTL level) are set as standard as follows: It can be easily modified to TSIP, TAIP, NMEA, and baud...