N016-V2, Lassen iQ / SQ Improved replacement GPS receiver, with parity ODD and WNRO management. Pole Phoenix - 22560 PLEUMEUR BODOU - FRANCE E-mail: [email protected] Copyright 2019 All Rights Reserved

IMPROVED PERFORMANCE: HEOL DESIGN has produced a new GPS receiver board, the N016-V2, which is based on the Trimble Copernicus high performance GPS chip set. This OEM board is designed for use in embedded and industrial applications requiring high accuracy positioning and timing information. It can also be used as a replacement and upgrade for users of the Trimble Lassen iQ receiver board (Part Number 46240-00). This GPS board receiver embeds an additional processor, to manage parity, WNRO, and other firmware features if necessary. ADVANTAGES: Ultra-high sensitivity of -160dBm, enabling high...

SUMMARY OF THE CHARACTERISTICS: Performances: Receiver Update speed Accuracy Horizontal (w SBAS) Altitude (w SBAS) Speed Time (pps) Initial acquisition time Cold (Time to First Fix) Warm start Hot start Reacquisition signal after signal lost Altitude Speed Acceleration Operating Temperature Storage Temperature 12 channels, -160dBm TSIP ⇒ 1Hz ; NMEA ⇒ 1Hz <2 meters (50%), <4 meters (90%) <3 meters (50%), <5 meters (90%) 0,06 m/sec (nominal)* ±60 ns < 39 seconds (90%)* < 35 seconds (90%)* < 3 seconds (90%)* < 2 seconds (typical)* < 18 000 m < 515 m/sec maximum 4 g (39,2m/sec) -40/+85 °C -55/+105°C...

b) 3 fixing pins allow you to solder firmly the N106 board on your mother board. These pins can be right angle (surface mount) : (other heigths available on request) Pole Phoenix - 22560 PLEUMEUR BODOU - FRANCE E-mail: [email protected] Copyright 2019 All Rights Reserved

EMC compatibility The HEOL-N016-V2 board has successfully completed compliance testing against the following standards listed below: (In accordance with the directive). EN55022 class B (conducted and radiated emissions) dated January 1999, with 10dB margin. EN61000-4-3 published in 2002: “Immunity tests on electromagnetic fields radiated at radio-electrical frequencies”, with 10V/m electromagnetic field. EN61000-4-6 published in February 1997: “Immunity tests on conducted interference, induced by radio-electrical fields”. EN61000-4-4 (Immunity to rapid transients) dated June 1995, with 2kV transients....

Factory settings of the serial ports The two communication ports (3.3V level) are set as standard as follows: Port A: • Input: TSIP protocol, 9600 Baud, 8 bits, parity ODD, 1 stop bit. • Output: TSIP protocol, 9600 Baud, 8 bits, parity ODD, 1 stop bit. Port B: • Input: NMEA protocol, 4800 Baud, 8 bits, no parity, 1 stop bit. • Output: NMEA protocol, 4800 Baud, 8 bits, no parity, 1 stop bit. Ordering part number The factory standard part number is N016-V2-R. However, customer can request several options, as described hereafter N016-V2-R Fixing pins: • S1 : 5.08mm Straight • S2 : 5.59mm Straight...