Mixhead and Injector Portfolio Overview

Introduction:
This document provides a comprehensive overview of the mixhead and injector portfolio as of October 2021, detailing discharge types, performance data, and available injectors.

Types of Discharge:
Discharge types are categorized into open mold, closed mold, spraying, and continuous. Models such as STATICJET, FIXJET, and FLEXJET are listed under these categories.

Performance Data:
Performance data for each mixhead model includes the number of components, laminar output, and output when mounted on a mold, presented in cm3/s and l/min.

Dimensions and Weight:
Each mixhead model is detailed with dimensions (height, length, width) and approximate weight in kilograms.

Selection Criteria:
Criteria for selecting the appropriate mixhead based on specific requirements are included.

Mixhead Models:
Various mixhead models such as MT-A, MN, MSL, ULTIMIX, and MEL are listed, each with specific performance ranges and dimensions.

Key Models and Specifications:

• MT-A Series: Models like MT-A 8-2, MT-A 12-2, and MT-A 18-2 with varying output capacities and dimensions.
• MN Series: Groove-controlled mixheads like MN 6-3 CSM and MN 10-4 CSM.
• MSL Series: Variable output mixheads such as MSL 90-Q and MSL 75.
• ULTIMIX Series: Stirrer mixheads like ULTIMIX C2-2 and ULTIMIX C60-2.
• MEL Series: Models like MEL-6C and MEL-8C with multiple components.

Specifications:
Models such as MXL 25-2, ML 25-4, MT 3-2, MT 6-2, MT 12-3 CC, MT 12-4, MT 36-2, MT-E 12-2, MT-E 18-2, and MT-E 26-2 are described with parameters like flow rate, pressure range, dimensions, and weight.

Procedures and Standards:
Dimensions and weights refer only to the mixhead housing, with variations based on configurations like hose lines, injectors, and sensors. Non-adjustable and manually adjustable injectors are available for different pressure applications.

Recommendations:
Guidance is provided on the suitability of different mixhead models for applications such as molded foam, spray, and HP-RTM. Optional components and interchangeable parts for color applications are highlighted.

Key Features:
Mixheads are categorized by design and functionality, including gas-loaded constant pressure injectors, spring-loaded injectors, and hydraulic closing mechanisms. Long versions and designs for MULTI-CONNECT technology are noted.

Additional Information:
A disclaimer states that the information is provided in good faith but is subject to change, and illustrations may not reflect the scope of supply.