Catalogs >
Hegewald & Peschke Meß- und Prüftechnik GmbH >
Swivel test rig for seating furniture

Swivel test rig for seating furniture
4Pages

Catalog excerpts

Swivel test rig for seating furniture - 1

Product Information Swivel test rigs for seating furniture e. g. acc. to EN 1335-3, EN 1728, BIFMA X5.1, Calmar one Hegewald & Peschke Meß- und Prüftechnik GmbH Am Gründchen 1, 01683 Nossen, Germany Telephone: +49 35242 445-0, Telefax: +49 35242 445-111 E-Mail: info@Hegewald-Peschke.de http://www.Hegewald-Peschke.com

Open the catalog to page 1

Swivel test rig for seating furniture - 2

Single test rig for performing various swivel and roller tests on swivel chairs, e.g. according to EN 1335-3, EN 1728, BIFMA X5.1 The seat load is either applied • statically by means of weight plates (to be ordered separately) which act on the seat compression piece (ø200 mm) via a guide rod (item no. 40-930-060), or • with a force controlled pneumatic axis Fmax 2500 N. (item no. 40-930-061) The force is applied vertically downwards. The load can thus be applied alternately every x cycles for y cycles. The PLC with analogue value processing is directly mounted to the test rig. The touch...

Open the catalog to page 2

Swivel test rig for seating furniture - 3

Optional accessories: • weight set 155 kg (7x20 kg, 1x10 kg, 1x5 kg), with calibration certificate (41-011-190) • 1 load pad 200 mm diameter acc. to DIN EN 1335 with clamping connection (41006-101) Technical data: power connection angular positioning ±10° or better angle range maximum loading rotation speed delay time configurable, minimum 0.1 s at each change of rotation direction In this case, the gas spring of the chair is located a few centimetres from the rotation axis of the plate during the test. If the direction of rotation is alternating, the swivel behaviour of the rollers is...

Open the catalog to page 3

Swivel test rig for seating furniture - 4

Overview of selected standards for turning tests: BIFMA X5.1 (2017) Seat load static 50mm eccentric at the back [rev./min] Breaks recommended not defined after every half revolution 41-006-101 or 41-006-220 360° 360° alternating or alternating continuously Swivel test point 7.3.3 load point A and C Roller testing point 7.3.5 load point A alternatively linear recommended after every half revolution 41-006-101 or 41-006-220 Swivel test point 7.11 load point A and C Roller testing point 7.13 load point A alternatively linear

Open the catalog to page 4