Pneumatic test axis, load or load/position controlled

Product catalog summary

Product Overview: The document provides information about the pneumatic test axis offered by Hegewald & Peschke, Meß- und Prüftechnik GmbH. This equipment is designed for installation in test stands or rooms and includes a controller for transmitting test software and control commands.

Specifications: The pneumatic test axis features a pivot fastening and can be connected to a central supply terminal that supports up to five test axes. It includes a pneumatic cylinder with contact-free signal emission, limit position damping, and a position measuring system. A load cell with a capacity of 5 kN is also included, along with a uniaxial controller for the pneumatic actuator, which is activated via CAN-Bus. The package comes with a 7-meter connecting cable for control voltage, CAN-Bus, and air supply, as well as a pivot fastening of 63 mm and a control unit.

Product Variants: The document lists several variants of the test axes based on load capacity and control type:

Test loads up to 1500N, load controlled (Order No. 41-041-120)
Test loads up to 1500N, load and position controlled (Order No. 41-041-121)
Test loads up to 2500N, load controlled (Order No. 41-041-130)
Test loads up to 2500N, load and position controlled (Order No. 41-041-131)
Test loads up to 4500N, load controlled (Order No. 41-041-140)
Test loads up to 4500N, load and position controlled (Order No. 41-041-141)

Contact Information: For further inquiries, Hegewald & Peschke can be contacted via phone at +49 35242 445-0, fax at +49 35242 445-111, or email at [email protected]. More information is available on their website at http://www.Hegewald-Peschke.com.

Catalog excerpts

Pneumatic test axis, load or load/position controlled-1

Hegewald & Peschke, MeB- und Pruftechnik GmbH Am Grundchen 1, 01683 Nossen Telefon: +49 35242 445-0, Telefax: +49 35242 445-111 E-Mail: [email protected] http://www.Hegewald-Peschke.com

Open the catalog to page 1

Pneumatic test axis, load or load/position controlled-2

Hegewald & PeschkeMeR- und Pruftechnik GmbH Pneumatic test axis with pivot fastening to be installed in test stands or test rooms. The controller is included and responsible for transmitting the test software and control commands. The test axis is connected with a central supply terminal which can carry up to 5 test axes. The fastening of the load plate is done with a standard clamp 20 mm. Included: • Pneumatic cylinder, contact-free signal emission, limit position damping, position measuring system • Load cell 5 kN • Uniaxial controller for pneumatic actuator; activation via CAN-Bus • 7 m...

Open the catalog to page 2