Hegewald & Peschke, MeB- und Pruftechnik GmbH Am Grundchen 1, 01683 Nossen Telefon: +49 35242 445-0, Telefax: +49 35242 445-111 E-Mail: [email protected] http://www.Hegewald-Peschke.com

/jd\ Hegewald & Peschke MeB- und Pruftechnik GmbH General Product description Our very robust 1D measuring device is a digital length measuring device made of steel and is used for length measurement on rod-shaped workpieces, tubes, profiles, rods, blanks, etc. in production environments. For measuring tasks where accurate measurements are a challenge, we offer a cost-effective alternative with this product. With the 1D-measuring device we guarantee a safe and fast measurement with easy operation in a rough production environment. Features • safe and fast measurement with simple operation in...

Optional and necessary accessories Display devices and software Display unit LG20-1: robust Magnescale® Display unit with reset/pre-set function. One measuring channel can be connected. Mains adapter PSC23 required. Display unit LY72: robust Magnescale® multifunctional display unit with large display, measured value plus error message, RS232 interface (HP KeySim required); up to three measuring channels can be connected. Display unit M3: digital Display unit M3 (4.3-inch color touchscreen, can be operated with gloves) incl. RS232 (HP KeySim required) and USB interface, no installation/no further...

Measuring accessories Standard Measuring stops standard: "Standard" means that the bare carrier surface serves directly as workpiece support and the contact surfaces are mounted just above the carrier surface. A continuous side stop bar (accessory) is used to align the workpieces. Workpiece supports are not required. - Measuring stops for holding touch surfaces 33-016-02x - Lateral stop bar over total length, hardened, ground Measuring stops heightened: "Heightened" means that additional workpiece supports can be attached to the carrier surface and therefore the contact surfaces are "heightened"....