Swedish Innovative Servo Motion Engineering Since 1994 Electric data For higher torques, see next page. Mechanical data (resolver feedback) Holding brake Overheat protection consists of triple PTC thermistors. Protection class HDD motors comply with the requirements for IP 65. IP-67 is available on request. Insulation class The insulation system complies with the requirements of EEC LV Directive 73/23/EEC and 93/68/EEC. Test report E9911111E01. Motor name structure Flange size Stator length Winding HDT = 10 pole shaft motor. Approximate in cm. 09 = 92 mm. E(shortest), J, N(longest). Suitable rail voltage at 6000 rpm. Feedback Power connector Brake Shaft key Options See the feedback list on www.hddservo.com/product-options/ Many different pinouts available; see www.hddservo.com/product-options/ A = no brake, D = holding brake. Data see above. A = shaft with key, B = shaft without key. AAA = standard. For other options please contact HDD. HDD Sweden AB | www.hddservo.com | [email protected] | +46 8 86 87 80

Torque Torque in Nm at 90ºC temp rise (median temp rise, i.e. average between min and max temp for 25% cycle). Current Current at 90ºC temp rise, in Ampere rms. Data were measured on an HDT 09N-Ma series motor mounted on a ver�cal 260 x 200 x 12 mm aluminum plate in free air, with a maximal winding temperature rise of 90ºC and driven by a commercially available nverter. Data are given for con�nuous opera�on and two drive cycles: 1 min on and 3 min off, and 3 min on and 9 min off, respec�vely. Data for other windings are calculated. Important note on peak torque and currents HDT motors are capable...