Swedish Innovative Servo Motion Engineering Since 1994 Electric data Mechanical data (resolver feedback) Holding brake For higher torques, see next page. Overheat protection consists of triple PTC thermistors. Protection class Insulation class HDD motors comply with The insulation system complies the requirements for IP with the requirements of EEC LV 65. IP-67 is available on Directive 73/23/EEC and request. 93/68/EEC. Test report Motor name structure Feedback Power connector Brake Shaft key Options See the feedback list on www.hddservo.com/product-options/ Many different pinouts available; see www.hddservo.com/product-options/ A = no brake, D = holding brake. Data see above. A = shaft with key, B = shaft without key. AAA = standard. For other options please contact HDD. HDD Sweden AB | www.hddservo.com | [email protected] | +46 8 86 87 80

Torque in Nm at 90°C temp rise (median temp rise, i.e. average between min and max temp for 25% cycle). Current Current at 90°C temp rise, in Ampere rms. Data were measured on an HDT 09E-Ma series motor mounted on a vertical 260 x 200 x 12 mm aluminum plate in free air, with a maximal winding temperature rise of 90°C and driven by a commercially available nverter. Data are given for continuous operation and two drive cycles: 1 min on and 3 min off, and 3 min on and 9 min off, respectively. Data for other winding types are calculated. HDT motors are capable of high peak torques. At very high peak...