P 411 4:1:1 WET ON WET PRIMER Technical Data Sheet No 122 General Technical Description High quality acrylic sealing primer Ideal for “wet on wet” application Mix 4 parts P 411 WET ON WET PRIMER with 1 part H 729 HARDENER FOR PRIMERS NORMAL Excellent adhesion on brand new surfaces. No need to sand. VOC compliant with the regulations Thinner / Reducer addition 25%: 740 ACRYL NORMAL THINNER or 741 ACRYL SLOW THINNER / REDUCER Surface OEM surfaces BRAND NEW UNSANDED PARTS CATAPHORESIS OEM PANELS (E-COATS) Plastic Bumpers & parts using 340 PLASTOFIX Pretreatment / Cleaning of substrate Clean substrate using a soft cloth and 770 ANTISIL NORMAL/ 771 ANTISIL FAST DEGREASER For WET on Wet application on BUMPERS ABRASE SLIGHTLY WITH P600-P800 WET. Make sure the surface is first wiped dry and then air dried Make sure you always use appropriate face protection and good ventilation Product Application: Wet on wet primer 1 pass »» Apply one coat as ”wet on wet” on metallic surfaces 4:1 mix with H 729 HARDENER FOR PRIMERS NORMAL Pot life: 60-80min @ 23°C (73ºF) 20 - 30 min / 23°C (73°F) Final flash off time Time depending on film thickness Addition 25% of thinner / reducer. Use 740 ACRYL NORMAL or 741 ACRYL SLOW THINNER / REDUCER 20-30 min can be recoated wet on wet with basecoat + clearcoat or 2K PUR paint Always wear protective equipment It can be painted over with HB BODY Color Solutions Basecoat Mix System HB BODY Color Solutions 2K Acrylic Mix System HB BODY Color Solutions Aquabase Mix System Follow the application instructions mentioned in this TDS 2K paint systems tend to react with water, hence all the equipment used must be moisture free. Isocyanates may cause skin sensitization. More specifically, care should be taken when handling the material. Anyone with a history of histaminic conditions, or respiratory problems should consult the doctor first. For professional use only. The information displayed on this sheet has been carefully selected through a series of laboratory investigations. It is based on our best knowledge at the time of issue. The data is given for information purposes only. We are not liable for its correctness, accuracy and completeness. It is up to the user to check for newer updates or further information if needed for his intended purpose. The intellectual property of this product, trademarks and copyrights is protected. All rights reserved. The relevant Material Safety Data Sheet and warnings displayed on the label must be read carefully. We may modify and / or discontinue operation of all or portions of this information at any time in our sole discretion, without any notice and assume no responsibility to update the information. All rules set forth in this clause shall apply accordingly for any future changes and amendments. HB BODY S.A. AUTO REFINISHING PRODUCTS, GREECE www.hbbody.

P 411 4:1:1 WET ON WET PRIMER Technical Data Sheet No 122 General Technical Description High quality acrylic sealing primer Ideal for “wet on wet” application Excellent adhesion on brand new surfaces. No need to sand. VOC compliant with the regulations Mix 4 parts P 411 WET ON WET PRIMER with 1 part H 729 HARDENER FOR PRIMERS NORMAL Surface Plastic Bumpers & parts using 340 PLASTOFIX Pretreatment / Cleaning of substrate Clean substrate using a soft cloth and 770 ANTISIL NORMAL / 771 ANTISIL FAST DEGREASER For application with 340 PLASTOFIX no sanding is necessary apart from PE plastics. Use P600-P800...