Flange connections For ductile iron pipes, PN 10 | PN 16 Double chamber flange adapter Design features No. 7102 • For ductile iron pipes according to EN 545 • Flange sized and drilled in accordance with EN 1092-2, PN 10 standard; EN 1092-2, PN 16 for DN 200 to DN 400 please specify on order - other standards on request • The long draw of the fitting and the double chambered gasket result in the pressure being spread well back from the pipe end • The resilience of the connection prevents tension in the pipe and minimises the danger of breakage Assembly instructions • Cut the pipe end straight, do not chamfer or moisten push the flange onto the pipe and then push the gasket on Flange adapter Design features No. 7602 • For ductile iron pipes according to EN 545 • Flanges sized and drilled in accordance with EN 1092-2, PN 10 tandard; EN 1092-2, PN 16 for DN 200 to DN 300 please specify on order other standards on request • Simultaneous pipe restraint and sealing • This avoids the need for pipe support and additional bolts to counter the effect of axial load and pressure. This connection can be easily dismantled at any time Assembly instructions • Assemble the flange with the sleeve gasket and pressure ring, and push onto the piece. Offer up the complete flange to the opposing flange, ensuring that the pressure ring projects approx. 10 mm over the end of the pipe. Cross tighten the nuts and bolts to make the connection. This fitting has the advantage that it can cope with a gap or an uneven cut that extends up to 15 mm from the opposing flange Tip: When shortening ductile iron pipes, observe the Ø ; Heed pipe manufcaturer's advice Flange made of ductile iron, epoxy powder coated Grip ring hardened steel Sleeve gasket made of elastomer Pressure ring made of ductile iron, epoxy powder coated Seal made of elastomer 7102 Double chamber flange adapter, standard 7602 Flange adapter, restraint 0102 Flange adapter, standard Explanation: * also available in PN 16, 1 Flanges with an extended hole circle are not suitable for use with

Flange connections For ductile iron pipes, PN 10 | PN 16 No. 7102 / 0102 No. 0102 Quantity Thread * DC flange with thread pin All illustrations, technical data, dimensions (in mm) and weights (all weights specified in kg) are non-binding. Subject to