Cable Glands Flameproof Exd & Increased Safety Exe Dual Certified ATEX / IECEx 'G' Approx (Fully Compressed Length) Inspectable Compound • Mining. • For use with pliable wire armoured cable. • For particular use with:- Pliable Wire Armour - Cables that are not effectively filled, compact and/or circular, Metric Entry have tape bedding or have hygroscopic fillers. - Cables that exhibit ‘Cold Flow’ characteristics. - Enclosures containing an ignition source. • See technical section for installation rules and regulations CABLE GLAND SELECTION TABLE Cable Acceptance Details Entry Thread Size Size Ref. Inner Sheath / Cores Hexagon Dimensions Pliable Wire Armour ‘C’ Across Flats Across Corners All dimensions in millimetres (except * where dimensions are in inches). Metric entry threads are 1.5mm pitch as standard, 15mm length of thread. ¹ Smaller value is applicable when selecting reduced NPT entry option. Technical Data • Flameproof Exd and Increased Safety Exe I M2. • Certificate No’s: Baseefa08ATEX0329X and IECEx BAS 08.0115X. • Suitable for use in Mines. • Construction and Test Standards: IEC/EN 60079-0, IEC/EN 60079-1 and IEC/EN 60079-7. • Ingress Protection: IP66, IP67 and IP 68 (30 metres for 7 days) to IEC/EN 60529. • Operating Temperature Range: -60°C to +80°C. • Assembly Instruction Sheet: AI 346. • Provides a barrier seal between the individual insulated cores • • • • • • within the cable and prevents entry of the products of an explosion into the cable. Assembly of the cable gland compresses and distributes the compound evenly to create a barrier seal at the point of entry into the enclosure. The compound chamber may be separated from the cured compound to ensure that the chamber has been effectively filled. If required, external voids can be repaired. Provides armour clamping for pliable wire armour. Provides a cable retention and low smoke and fume, zero halogen seal onto the cables outer sheath. Manufactured in Brass (standard), Nickel Plated Brass or 316 Stainless Steel. Brass NPT entries are nickel plated as standard. Ordering Information Format for ordering is as follows: Cable Gland Type 653/T Cable Gland Type 653/T Two part sealing compound and assembly instructions are supplied with the cable gland. Connection Solutions www.ehawke.com