CABLE GLAND 501/RCG Increased Safety, Dust Protection Certified ATEX / IECEx / UKEx 1 Quick disconnect pin and socket arrangement inside the body of a gland International Approvals 2 Reversible Armour Clamp - For all types of armour and braid 3 Patented Cable Gland Tightening Guide - Helps prevent damage caused by over tightening 4 Unique Rear Seal - Offering ultimate sealing over an extremely wide cable acceptance range The 501/RCG is certified Exe/Ext, and can be used for quick field connection of cables to equipment where historically hard wiring methods are used. The product offers cost savings when carrying out essential inspection and maintenance activities, including the capability to quickly swap out equipment on-site. 501/RCG Selection Table Body Size Outer Sheath Inner Sheath Seal/Ring Size Steel Wire Armour/Tape/Braid Orientation 1 Entry Thread Max Hexagon Dimensions Across Flats Across Corners For Alternative Ring with 6-pin B size add “AR” to end of code string Technical Data Ingress Protection Deluge Protection Voltage Rating Dependent on conductor size, see T-Rating Selection Table Conductor Sizes Over Insulation Acceptance Diameters Entry Side: Ø4.75mm Body Side: Ø5.50mm Operating Temperature -60°C to +60°C (may be limited by T-Class) ATEX/IECEx ATEX/IECEx Protection Class Ex II 2 GD Ex eb IIC T6/T5 Gb, Ex tb IIIC T80°C/95°C Db Suitable for use in Zone 1, Zone 21, Zone 2 and Zone 22 Construction & Test Standards For all sales and product enquiries please contact Hawke Sales Additional Certifications IEC/EN 60079-0, IEC/EN 60079-7 and IEC/EN

CABLE GLAND Ordering Information Name Product Type Entry (Supplied with Energised Cap) Body (Supplied with Energised Cap) Entry and Body (Supplied with Transit Caps) Contact size Selection only required for Body Style E and G S Cable OD Selection only required for Body Style B and G Supplied Brass Nickel Plated as standard Crimp tool for Entry assembly recommended, order part code HTC2 Insert tool for Entry assembly required, order part code RCGT1 For Alternative threaded entries, a 476 thread adaptor may be required For additional clamping and to meet IEC EN BS 60079-14 10.3, the GMC can be...