Cable Glands 15.0mm 'G' Approx (Fully Compressed Length) Armour/Braid 'C' Metric Entry armour ‘Y’ and steel tape armour ‘Z’ elastomer and plastic insulated cables. Entry Thread • Outdoor or indoor use. • For use with single wire armour ‘W’, wire braid ‘X’, aluminium strip CABLE GLAND SELECTION TABLE Entry Thread Size Size Ref. Metric Os O A B C C2 D E F G H J Hexagon Dimensions Cable Acceptance Details Across Flats Across Corners All dimensions in millimetres (except * where dimensions are in inches). Os - F size metric entry threads are 1.5mm pitch as standard, 15mm length of thread. For G size glands and above, a 2mm pitch is supplied as standard, 20mm length of thread (1.5mm pitch with 15mm length of thread can be supplied) please specify when ordering. ¹ Smaller value is applicable when selecting reduced NPT entry option. ² Sizes Os and O are available with an M16 thread size. For O size with M16 thread, the maximum cable outer sheath diameter is 10.9mm Technical Data • Construction and Test Standards: EN 50262, BS 6121 : Part 1 Type CW, CX, CY and CZ. • Ingress Protection: IP66 to IEC/EN 60529. • Deluge Protection to DTS01 (Deluge Seal Optional). • Operating Temperature Range: -60°C to +100°C. • Assembly Instruction Sheet: AI 393. • Provides armour clamping using one clamping arrangement for all armour / braid types. • Provides a cable retention and low smoke and fume, zero halogen seal onto the cables outer sheath. • Manufactured in Brass (standard), Nickel Plated Brass, 316 Stainless Steel or Aluminium. • Brass NPT entries are nickel plated as standard. Alternative Reversible Armour Clamping Rings (RAC) Ordering Information Format for ordering is as follows: Alternative Clamping Ring (AR), add suffix AR to ordering information. Cable Gland Type 151/RAC Cable Gland Type 151/RAC