Anchor Nuts Part No. Anchor Nuts consist of a steel zinc plated nut in a nylon or steel cage. They offer a simple but effective fastening solution for thin materials. It is installed by placing the wings on the nut into the special hole and then turned through 90°. When the screw is tightened the wings then clamp the plate. The special hole can be drilled then clipped out with a hand-clipping tool. For larger volume applications the required hole should be punched.Materials & Finishes:-Cage Nylon 66 Nut Steel Trivalent ZincTo specify use Series Code / Part No/ (eg 50505 AN060) All information is given for guidance only and designers should satisfy themselves as to the suitability of the specification by requesting samples