Polyplast 30 Pozi Flange Head Part No. Non-preferred (Possible Lead Times) Usually Available from Stock Special Order Only All information is given for guidance only and designers should satisfy themselves as to the suitability of the specification by requesting samples

Continued from previous page... The 30 deg. Flank angle produces low radial forces when engaging the plastic, therefore resulting in less radial stresses, in other words the hoop stresses in the plastic bosses are less than those experienced with conventional screws. The recessed core geometry provides the ideal flow director for the displaced plastic, encouraging a uniform flow to fill the pitch of the screw without material jamming. This results in the maximum amount of plastic being engaged providing higher sheer loads and pull out force. Material: Steel Finish: Zinc Plated For the part number...