Harrison Silverdale Ltd Unit 1 Traso Business Park. Callywhite Lane. Dronfield, Sheffield, S18 2XR Tel: 01246 296 930 • Fax: 01246 296 940 Email: [email protected] Internet: http:/fwww.harrisonsilverdale.co.uk Polyplast 30 Flange Head Part No. Substitute the drive code for the ? and the length for the L In the part no. to specify the exact part required. The 30 deg. Flank angle and recessed core diameter of these thread forming screws for plastic have been developed following theoretical appraisal, exhaustive calculations and final proof testing. The 30 deg. Flank angle produces low radial forces when engaging the plastic, therefore resulting in less radial stresses, in other words the hoop stresses in the plastic bosses are less than those experienced with conventional screws. The recessed core geometry provides the ideal flow director for the displaced plastic, encouraging a uniform flow to fill the pitch of the screw without material jamming. This results in the maximum amount of plastic being engaged providing higher sheer loads due to the increased bearing depth of the thread. A combination of the above and the ease of penetration of the 30 deg. Flank angle through the material, encouraging plastic flow, reduces the torque required to drive the screw in. This therefore increases the margin between drive and stripping torque which minimises the potential of stripping during installation. The optimum pitch and maximum fill features provided by the recessed core results in a large area of plastic to be sheered prior to screw failure in tension. This creates a high resistance to pullout loads. All information is given for guidance only and designers should satisfy themselves as to the suitability of the specification by requesting samples