HI 200DNWM
2Pages

DeviceNet Weigh Module Series B Applications PROCESS WEIGHING • Batching/Blending • Filling/Dispensing • Level-by-Weight • Check Weighing • Force Measurement Features WAVERSAVER® • Ignores vibration on and around • Electronic calibration without test THE BUTTON • One step calibration with C2 load CONFORMANCE TESTED The HI 200DNWM is a general purpose weigh module designed specifically to the DeviceNet Open Network Standard. Its' many features, including "calibration with the push of a button", have set the norm for all future DeviceNet weighing products. FEATURES • The HI 200DNWM Series B now allows easier programming and increased flexibility through features such as: • A "Command Interface" for easy access to all parameters without the use of explicit messages • A choice of outputs with selectable decimal point location • A selectable update rate of 10 or 55 samples per second The HI 200DNWM supports up to eight C2® certified load sensors and provides power to scales with up to four 350-ohm standard strain gauge load cells, load sensors or load points. It receives and digitizes the weight signal with over one million bits of resolution, and transmits the selectable Gross, Net and Tare weight data over the DeviceNet Open Network interface to other devices. Data is transmitted at three switch selectable baud rates of 125, 250 or 500 kilobytes per second. The DNWM acts as a slave on the network and supports a polling I/O exchange mechanism. Two on-board bi-color LEDs provide module and system status for troubleshooting. SET POINTS Two independent TTL level outputs provide set point capability each with separate deadbands and preacts for control capabilities in a variety of weighing applications. C2® ELECTRONIC CALIBRATION C2 enables electronic calibration of the weigh system without test weights. This saves system start-up costs and aggravation. Of course, even if C2 certified load sensors are not used, the system can still be calibrated the slow, traditional way using certified test weights. WAVERSAVER® WAVERSAVER eliminates the effects of unwanted plant vibration on or around the scale by permitting the weigh module to “see” through the unwanted vibration signals - as low as 0.25Hz - while yielding a stable actual reading. THE BUTTON® With one push of a button the weigh scale module automatically calibrates the weighing system, making it ready for use. This saves system start-up time costs and aggravations. ADDITIONAL FEATURES This module comes with a disk containing the Electronic Data Sheet (EDS) and a user's manual. This product is available for dual stacking in an instrument cabinet, on standoffs, or on din rail, It is also available with a summing card packaged in a painted steel NEMA 4 or Stainless steel NEMA 4x junction box.

COMPONENTS TO COMPLETE YOUR HARDY SYSTEM Hardy Bench Scales, Floor Scales and Load Points Hardy carries a wide variety of strain gauge load points and scale bases to accommodate your application requirements. ADVANTAGE Series Load Point with C2 Calibration ANY-WEIGH Scales Hardy C2 Certified Cable This 8-conductor cable is designed for optimizing weight and load sensor characteristic signals from the junction box to the instrument. Hardy Junction Box (HI 215 Series) This NEMA 4 rated waterproof enclosure sums from one to four load sensor signals. ORDERING INFORMATION Input Power • Provided...