Catalog excerpts
DUCT HARDWARE & NEXUS FLANGE Contributes to LEED” Credit Requirements DynAir Stud-Lock/Spring-LockInternal Reinforcement Conduit Locks FEATURES AND BENEFITS • Conduit locks are easy to install and minimize labor when compared to conventional reinforcement systems • NO crimping required • NO de-burring required • NO plastic components • Tested up to 10" w.g. • Minimum 2,000 lb. pull- out strength • Designed to fit %" and %" EMT conduit • Simple, quick and repeatable installation equipment in either single or dual-head configurations • 150% stronger than plastic plugs Conduit locks allow one person to easily install conduit sections into HVAC ductwork for proper internal reinforcement as defined in the SMACNA Duct Construction Manual. The tie rod construction system encompasses Stud-Lock and Spring-Lock conduit locks. The Stud-Lock is a solid stud that will protrude through the exterior of the ductwork and allow the gasketed washer and locknut to be attached. This gives a solid and leak tight seal on the exterior of the ductwork. The Spring-Lock shares all of the same features as the Stud-Lock however, the stud is spring-loaded. This allows the user to depress the stud to easily insert through the exterior of the ductwork. Typically the Stud-Lock and Spring-Lock are combined to have a solid stud on one end of the conduit and spring-loaded stud on the opposite end. This gives the user the best combination at the most valuable cost and allows a much easier install without having to scratch or deform the duct to insert the stud. DESCRIPTION %" Stud-Lock (250) %" Stud-Lock (250) %" Spring-Lock (250) %" Spring-Lock (250) Single Rammer Install Tool Dual Head Rammer Install Tool HARDCAST AESnSMSM COMPANY- USA: 900 Hensley Lane, Wylie, TX 75098 • (877) 495-4822 Canada: 205 Brunswick Boulevard, Suite 300, Pointe-Claire, QC H9R 1A5 • (800) 544-5535 www.hardcast.com P/N 605757 - DynAir Stud-Lock/Spring-Lock TDS 06.29.17 Carlisle is a trademark of Carlisle. Hardcast is a trademark of Hardcast. © 2017 Carlisle.
Open the catalog to page 1All Hardcast catalogs and technical brochures
-
Fab Guard
1 Pages
-
Dyn-O-Tac II
1 Pages
-
Dial-a-Matic™
1 Pages
-
Degalvanizer
1 Pages
-
Booth-Tack™
1 Pages
-
Access Door Handle
1 Pages
-
Ball Joint
1 Pages
-
Cartridge Killer
1 Pages
-
Exterior Line Set Protection
1 Pages
-
PROJECT PROFILE
1 Pages
-
Flashing Tapes
1 Pages
-
SPRAY-SEAL™
4 Pages