10.0 PHT/CE- K

Product catalog summary

Specifications:
- Maximum pulling capacity: 10,000 kg (22,040 lbs)
- Maximum rope length: 42 m (140 ft)
- Recommended wire rope: 16 mm (5/8")
- Hydromotor capacity: 160 cc (9.6 in³)
- Maximum pump flow: 60 lt/min (15.8 gal/min)
- Gear ratio: 28:1
- Oil type and capacity: 85W 140, 2 lt
- Maximum working pressure: 155 bar (2,247 psi)

Performance:
- Pulling capacity decreases with each additional rope layer, starting from 10,000 kg (22,040 lbs) at the first layer to 5,866 kg (12,930 lbs) at the fifth layer.
- Rope speed ranges from 6 m/min (21 ft/min) to 10 m/min (35 ft/min) depending on the layer.

Standards and Features:
- Includes cable tensioner and roller fairlead.
- Hydraulic inlets: G 1/2’’
- Optional air clutch available.
- IP67 - IP68 rated.
- Mounting bolts: 16 pieces M16 8.8
- Features a 100% holding negative-acting hydraulic brake system.
- Light and powerful design with extra reinforced cast body through heat treatment.

Warnings and Recommendations:
- Ensure A-B lines are open to T line (tank line) of the control valve in center position before operation.
- Designed for pulling only; do not lift people or materials.
- Always keep the last 5 wraps on the drum.
- Technical details are subject to change by the manufacturer.

Pneumatic Working Pressure:
- Minimum to maximum: 9 – 12 bar (130 - 174 psi)

Catalog excerpts

10.0 PHT/CE- K Extra reinforced cast body through the heat treatment and industrial design Light and powerful design %100 Holding Negative-Acting Hydraulic brake system. Standard Pressure Roller and Roller Failead. Easy assembly, compact design and high torque hydromotor Standard manual rope unloading system HMW 10.0 PHT/P Air Clutch HMW 10.0 PHT Manual Clutch Recommended wire rope (mm / in) Gear ratio: Rope Winding Layer Rope Speed Roller Fairlead : ( kg / lbs ) 16 kg 35,2 lbs Cable Tensioner 7 kg 15,4 lbs Mounting Bolts 16 pieces M16 8,8 Standards Cable tensioner Roller Fairlead Optinal Air Clutch IP67 - IP 68 Hydraulic Inlets G 1/2’’ Warning !! Before operate the winch, A-B lines must be open to T line (tank line) of the control valve in center position. This winch is desingd and manufactured for pulling, don’t lift person or metarial. Always keep last 5 wrap on the drum. The tecnical details given above just for infarmation. HAMMER WİNCH keeps the to change the tecnical. details Pneumatic Working Pressure: Min - Max 9 – 12 bar (130 - 174 psi)

Open the catalog to page 1

10.0 PHT/CE- K

10.0 PHT/CE- K

Catalog excerpts

All Hammer Winch catalogs and technical brochures