HAM-LET METERING BALL VALVES MBV SERIES

METERING BALL VALVE (MBV) SERIES FEATURES On/Off and metering service PFA Encapsulated ball stem design Panel Mounting as standard MAWP 2000 psi (137 Barg) MAWT 300°F (150°C) Size Range from 1/8" to 3/8" & 3mm to 6mm Variable end connections: LET-LOK® ; FNPT ; MNPT ; Male Face Seal 1°, 3° and 5° Stem Taper for required flow control Stopper shoulder stem for long life service The Shut-off Metering Ball Valve Series provides the highest degree of precision metering for moderate pressure applications. This series features innovative and unique shut-off capability and allows full control of the process...

METERING BALL VALVE DIMENSIONS panel hole) panel hole) F (Required panel hole) Basic Ordering Number Stem Taper Angle

FLOW SETTING The H, F and X Series metering ball valve designs were tested for proof and burst. MBV-H series metering valve is tested for bubble tight shut-off at 100 psig (6.8 bar) differential pressure. Every MBV - H, F & X metering valve is factory tested with Nitrogen at 1000 psig (69 bar) for leakage through the seat. No detectable leakage is allowed during shell test. MBV-F series metering valve handle dead stop is set at 4 to 10 std cm3/min with 5 psig (0.34 bar) inlet pressure. MBV-X series metering valve handle dead stop is set at 4 to 10 std cm3/min with 15 psig (1.0 bar) inlet pressure....

CLEANING & PACKAGING Every MBV series Metering ball valve is cleaned in accordance with Standard Cleaning and Packaging (procedure 8184). Oxygen Clean & Lubricant-Free Cleaning and Packaging, in accordance with Special Cleaning and Packaging (procedure 8185), is available as an option. Lubricant-Free cleaned valves have significantly higher actuation torque. Ball Valves are designed for operation in the fully closed or fully open position. Initial packing adjustment is recommended after installation and prior to start-up TECHNICAL DATA Pressure - Temperature Ratings Temperature Rating O-ring...

METERING BALL VALVE ORDERING INFORMATION Valve Series Body and Ends Material Metering Handle Options O-Ring Material Blank Standard Handle (3) Metering Type End Connection Type Vernier Handle Standard Stem Taper- 5° Fine Stem Taper- 3° Yellow Aluminum Handle (4) Extra Fine Stem Taper-1° Green Aluminum Handle (4) Blue Aluminum Handle (4) LET-LOK Ends Female Ends Male Ends Male to Female Ends (1) Male to LET-LOK Ends Male Face Seal Treatments Standard Blank Cleaning & Oxygen Clean Lubricant Free Silicone Free Ball Handle Options Black Nylon Blue Nylon Handle Yellow Nylon Handle Green Nylon Handle...