corrosion resistance tester
1Pages

{{requestButtons}}

Catalog excerpts

corrosion resistance tester - 1

£HWte Product description if, SJgjtj6OoC0f]S7.K't'6'M\Brf Js. The machine is used to perform corrosion strength of cutlery. The test specimens are intermittently immersed in a 1 % solution of sodium chloride (NaCI) at 60 TTfor 6 h. The number and size of any pits that have formed are measured visually with the aid of a microscope lens. Technical parameters I.SJtsEH: 60TO ± 2°C ; 2.Cycle speed controllable from 2~5 cycles per minute. 4. Ceramic heater was used for heat source. 5.Pneumatic cylinder was used to lift up and down the fixture rack. 6. PLC programmable controller, LCD touch screen interface Product description The machine is used to test handle fatigue of cutlery, it load the handle, raising and lower under 15000 cyclic, then check the handle deformation or loose. Technical parameters 1 *50 ± loSSffU&S I.The level surface was covered by a 5 mm thickness rubber having a hardness 50 ± 10 shore. 2.Test cyclic: 15000 cyclic (adjustable) 3.Lower and raising speed of the test specimen : 25 times/minute. 4.Fixture: two fixtures suitable different cutlery 5.Out dimension: (L x W x H) 625mm x 450mm x 750mm 6.Power: 1 phase, AC 220V, 50 ~ 60Hz. 7.Design standard: BS EN 12983

Open the catalog to page 1

All HAIDA EQUIPMENT CO. catalogs and technical brochures

  1. IP ratings

    2 Pages

  2. Safety shoes

    2 Pages

  3. Drop Tester

    3 Pages

  4. WHAT IS ISTA

    2 Pages

  5. Battery Test

    6 Pages

  6. Tape Tester

    1 Pages

  7. History

    1 Pages

  8. Eid al Adha

    1 Pages

  9. ISTA MEMBER

    1 Pages

  10. Catalog

    1 Pages

  11. HD-B615

    1 Pages

  12. HD-E702

    1 Pages

  13. HD-703

    1 Pages

  14. HD-E704

    1 Pages

  15. tensile tester

    13 Pages

  16. drying oven

    1 Pages

Archived catalogs