Force Sensor ZAD Scope of Supply Force sensor with 5 m cable (PVC), axial output with cable connection T: cable gland, straight and two fastening nuts M25x1.5 Variants N2: Plug connection, straight, M12, moulded S2: Plug connection, right-angled, M12, moulded Additional Options F: For use in explosive areas, incl. J-Box Special features • Easy assembly and small space requirement • Overload protection utilizing mechanical stops • Measuring range from 10 to 500 N Tension force sensors of the type ZAD were specifically developed for direct measurement of forces acting in cables, wires, ropes, or tapes. They can best be installed in places where the design of the machine already requires the use of deflection rollers or guide rollers. This is e. g. the case in situations such as - cable making machines - stranding machines - foil capacitor manufacturing - label printing machinery etc. Ordering example ZAD500-S2 Type Nominal force Variants/ Options When using an application of force transmission screw instead of a roll the tension sensor ZAD may be used as a compression load cell. The axial cable entry allows in most cases a simple installation on the machine. Mechanical stops limit the measurement path and serve as overload protection. The sensor is designed according to the double beam principle. This results in high precision measurement even in off center load situations. Strain gauges applied to the active surfaces of the cantilever beam measure the acting forces. The strain gauge bridge is supplied with stabilized DC voltage from a strain gauge amplifier of the HAEHNE program for further processing of the measuring signals. HAEHNE Elektronische Messgerate GmbH ■ Heinrich-Hertz-Str.29 ■ D-40699 Erkrath Germany ■ Telefon 0211/92591-0 ■ Fax 0211/92591-20 http://www.haehne.de Email: [email protected]

HAEHNE Technical Data Absolutely pay attention: Red dot in measuring direction! * Attention! When assembling axes adapters, pulleys or similar devices no torque should act on the inner sensor part. For this reason assembly should be made before installation into a machine; use wrench for countering. ZAD PB EN 06_15.indd Dimensions in mm (1 mm = 0.03937 inches) Technical modification reserved. HAEHNE Elektronische Messgerate GmbH ■ Heinrich-Hertz-Str.29 ■ D-40699 Erkrath Germany ■ Telefon 0211/92591-0 ■ Fax 0211/92591-20 http://www.haehne.de Email: [email protected]