Force Measurement Bolt KMB-A Scope of Supply Force sensor with 5 m cable (PVC) with amplifier output C (current output 4…20 mA) and connection variant T: cable gland, straight Variants U: Voltage output ± 0 - 10 V S2: Plug connection, right-angled, M12, moulded Additional Accessories Spring cotter for axial lock Special Features • With integrated amplifier Picture similar • Simple mounting even in confined spaces • Easy retrofitted into existing machinery • Measuring range from 6,3 to 63 kN The force measurement bolt KMB-A was specifically developed to capture tension and compression forces in machine parts equipped with standard fork heads, e.g. in conjunction with pneumatic and hydraulic cylinders. The KMB-A can be used in all applications where such fork heads are either already available or can be easily retrofitted. Simple and cost effective mounting of the KMB-A make it especially suitable for up-grading existing equipment. Tension Spring cotter for axial lock Fit in commercially available standard fork heads Compression (Calibration direction) Polarity* of the bridge output signal Positioning slot above Attention! Installation instruction Ordering Example KMB-AC20-10k-T Typ Output signal Diameter Nominal force Variants *Align positioning slot according to action line of the measuring direction. In order to obtain reverse polarity turn the KMB by 180° (positioning slot is at the bottom). Select „voltage version U“ for sensors with negative preload, as the variation C can process only positive loads. A potential equalization cable with sufficient cross section has to be provided, when mounting the amplifier to grounded machine parts. HAEHNE Elektronische Messgeräte GmbH · Heinrich-Hertz-Str. 29 · D-40699 Erkrath Germany · Telefon 0211/9  25 91-0 · Fax 0211/9 25 91-20 http://www.haeh

HAEHNE Technical Data Sensor Standard: Calibration in positiv measuring range, KMB12 ...KMB35 are calibrated to tension, KMB50 to compression load *) With variant U this line is not in use. The reference potential of the signal is 0 V of the amplifier supply KMB-A PB EN 01 16.indd Technical modifications reserved HAEHNE Elektronische Messgerate GmbH ■ Heinrich-Hertz-Str.29 ■ D-40699 Erkrath Germany ■ Telefon 0211/92591-0 ■ Fax 0211/92591-20 http://www.haehne.de Email: [email protected]