Product Description Electronic unit - Fastening material - Gasket Special Features - Option D: with red backlightning  Automatic zeroing circuit  Built-in scaling provided  DIP switch selectable decimal point  Front panel bezel meets - IP 65 Ordering Data: PM2-D Typ Option Panelmeter cut-out: DIN 68 mm x 33 mm. Fastening with mounting brackets. This panelmeter is primarily used for displaying signal voltages. In conjunction with load cells and amplifiers this unit is equally well suited for the display of force measurement values. The unrestricted selection of the decimal point and the scaling of the signal allow the real-time display of other values for instance web tension forces. The enclosure is suitable for the front panel mounting or for switch cabinets. HAEHNE Elektronische Messgeräte GmbH · Heinrich-Hertz-Str. 29 · D-40699 Erkrath Germany · Telefon 0211/9  25 91-0 · Fax 0211/9 25 91-20 http://www.haehne.de

HAEHNE Technical Data Factory adjustment: Display 10.00 at 10 V input voltage Determination of division factor D Real Time Display (S5=1) with U: Nominal input voltage A: Display with nominal input voltage P: Decimal point position 0.000 4 1 00.00 4 10 000.0 4 100 0000 4 1000 Adjustment - Select appropriate DIP switch, - Apply nominal input voltage, - Adjust with Scale Pot the desired value. O The 0 V ground or a reference potential of the power n supply and the amplifier circuit are connected internally. The input signal refers therefore to the 24 V-GND connection. In order to avoid measuring errors...