Group: Gurit Heberlein AG
Catalog excerpts
WL U V C u r i n g C o m p o s i t e Te c h n o l o g y Wet Laminating System NEW: UV curing resin system developed for out of the mould blade finishing and in-mould repairs. Fast curing single component resin system developed to save time, effort and waste in processing blade repairs. n UV Curing resin system with dedicated RENUVO™ Lamp Technology n Optimised viscosity for excellent fibre wet out n Single component resin technology n GL Certification pending n Clean processing avoiding mixing and contamination Introduction RENUVO™ Wet Laminating System (WL), is a breakthrough UV curing resin system, developed by Gurit as a repair system for straight from the mould turbine blades. RENUVO™ WL offers a step change in materials for the repair market. RENUVO™ WL has demonstrated a practical solution to an engineering problem, how to perform out of the mould repairs efficiently. The single-component RENUVO™ WL resin eliminates the human error of mixing, dispensing and working associated with traditional 2-component repair systems. Additionally the material offers the operator the security that wherever the material has been sourced it is the same product manufactured to the same high exacting process. PDSWE-RENUVO WL -2-0312 1
Open the catalog to page 1The product should be applied out of direct sunlight to extend the working time. Specific Formulated product working practices apply to this product, details of which can be obtained from Gurit by the Composite Processing department. * Fibre dominated. Properties normalised to 53% FVF t Laminate construction for compressive coupons is 3 x XE603
Open the catalog to page 2Transport & Storage RENUVO™ WL should be kept closed from light sources during transport and storage. Adequate long-term storage conditions will result in a shelf life of 1 year at 21°C. Storage should be in a dry place out of direct sunlight, incandescent light and protected from frost. The long-term storage temperature should be between 10°C and 25°C. The product may however be stored between +5°C and 30°C prior to application. It is recommended that it be stored in the original container to protect the product from ambient UV light. Notice All advice, instruction or recommendation is...
Open the catalog to page 3All Gurit catalogs and technical brochures
-
GURIT® G-PET™ FR
4 Pages
-
FST Materials Brochure (v10)
7 Pages
-
PREPREGS
11 Pages
-
Gurit Guide to Composites
76 Pages
-
EH 275 / EP 114
4 Pages
-
Carbon & Glass SparPreg
5 Pages
-
General Datasheet PN 901
4 Pages
-
General Datasheet PN 900
4 Pages
-
General Datasheet PB1000
4 Pages
-
RA320H5
1 Pages
-
XA450
1 Pages
-
UT-EA661
1 Pages
-
REA390S
1 Pages
-
PB1000
2 Pages
-
Adhesives Brochure (v7)
5 Pages
-
Core Materials Brochure (v8)
9 Pages
-
GURIT PRODUCT CATALOGUE 2013/14
82 Pages
-
UT-E1200
1 Pages
-
UT-E800
1 Pages
-
UT-E500
1 Pages
-
UT-E250
1 Pages
-
Carbon SparPreg (v9)
4 Pages
-
RENUVO Prepreg PP (v4)
3 Pages
-
Gurit Guide to Composites (v5)
73 Pages
Archived catalogs
-
Corecell P-Foam
2 Pages