Catalogs >
Gurit >
Carbon SparPreg (v9)

Carbon SparPreg (v9)
6Pages

Catalog excerpts

Product Information A range of fibre types can be utilised with SparPreg™ to suit the application. SparPreg™ can be used with both SPRINT® and prepreg products. It is supplied with a poly backer and can be applied to the substrate with either side against the tool. SparPreg™ can also be used as a normal prepreg. SparPreg™ allows the customer to lay-up thick UD sections and achieves excellent laminate quality with low void content, without the need for debulking or dry fabric reinforcement to remove air from between the plies. For optimum results a lay-up temperature less than +18°C is...

Open the catalog to page 2

Prepreg Properties Minimum Cure Time & Temperature Transport & Storage Recommended minimum cure is 10 hrs at 85°C. When stored sealed & out of direct sunlight. Cure Time (minutes) Please refer to product MSDS for up to date information specific to this product. All prepreg materials should be stored in a freezer when not in use to maximise their useable life, since the low temperature reduces the reaction of resin and catalyst to virtually zero. However, even at -18°C, the temperature of most freezers, some reaction will still occur. In most cases after some years, the material will become...

Open the catalog to page 3

Applicable Risk & Safety Phrases R 36/38, 43, 51/53 S 24, 26, 28, 37/39, 57, 60 Health and Safety The following points must be considered: 1. Skin contact must be avoided by wearing protective gloves. Gurit recommends the use of disposable nitrile gloves for most applications. The use of barrier creams is not recommended, but to preserve skin condition a moisturising cream should be used after washing. 2. Overalls or other protective clothing should be worn when laminating or sanding. Contaminated work clothes should be thoroughly cleaned before re-use. 3. Eye protection should be worn. If...

Open the catalog to page 5

Transport & Storage All prepreg materials should be stored in a freezer when not in use to maximise their useable life, since the low temperature reduces the reaction of resin and catalyst to virtually zero. However, even at -18°C, the temperature of most freezers, some reaction will still occur. In most cases after some years, the material will become unworkable. Notice All advice, instruction or recommendation is given in good faith but Gurit AG (the company) only warrants that advice in writing is given with reasonable skill and care. No further duty or responsibility is accepted by the...

Open the catalog to page 6