Catalog excerpts
welding and cutting automation Submerged arc welding carriage - sam® The versatility and reliability of the Gullco MOGGY® trackless travel carriage system and a variety of quality engineered components combine to provide a highly flexible self-contained welding unit. This SAM® unit is designed to produce precision, quality Submerged Arc or MIG welds. The SAM® Carriage, friction drive heavy-duty welding carriage, with positive chain drive on four (4) rubber tired wheels using a closed loop tack feedback for accurate speed control. The carriage controlled by the Gullco low voltage 24 volt GSP microprocessor pulse width modulation motor control, all mounted in a remote pendant control box attached to 8 ft. (243.84 cm) control cable housing the GSP control providing the forward/stop/reverse switch and infinitely variable 4-turn speed potentiometer. LED display in IPM or cm/min. An interface cable assembly allows the Miller HDC 1500 DX to control the run/stop function of the SAM® Carriage. A manual clutch enables free wheeling. The carriage comes complete with a main mounting mast and handle assembly, mounting arm for one wire reel. All the mounting arms are equipped with quick jaw mast clamp assembly; vertical and horizontal manual 4” x 4” slides (with hardened ground rods with sleeve bearings for ease of adjustment). Control support arm and one (1) set (two[2]) adjustable guide roll arms. For operation on either 42/115/230 volts, single phase, 50/60 Hz AC power supply. Specify voltage when placing order - B = 115 V, C = 230 V. SAM® Carriage comes in a model for mounting customer’s supplied single sub-arc package. Carriage specifications same as Model GM-02-295. No welding equipment is supplied. Automate Submerged Arc Welding Applications HEAVY DUTY SAM® TRACKLESS WELDING CARRIAGE FOR SUBMERGED ARC AND MIG WELDING
Open the catalog to page 1GM-02-250 SAM® Heavy-Duty Friction Drive Carriage The carriage specifications are the same as that of the GM-02-295, but provided with 17” x 22” (43.18 x 55.89 cm) aluminum plate providing full flat mounting surface for customer’s supplied wire feeder. SAM® Submerged Arc Carriage...Shown set at 45° for beam welding applicationSAM® Heavy-Duty MIG Carriage...Shown supplied with optional steering mechanism and mast assembly Special track and wheels -available upon request. Power Supply: For operation on either 42/115/230 volts, single phase, 50/60 Hz AC. (Specify voltage when placing order - B...
Open the catalog to page 2All Gullco International Limited catalogs and technical brochures
-
KAT® 300 SERIES
2 Pages
-
KATBAK® Ceramic Weld Backing
3 Pages
-
GK-200
2 Pages
-
GOV 100 FH - 100
2 Pages
-
Pipe KAT- Rigid Band
4 Pages
-
Pipe KAT - Operation
56 Pages
-
KAT® Rigid Track Carriage
4 Pages
-
GK-192
1 Pages
-
rigid kat
1 Pages
-
Customized Welding Gantry
4 Pages
-
Vacuum Track Mounting System
4 Pages
-
Welding Positioner
4 Pages
-
Cutting Carriage - KAT II
2 Pages
-
Auto-Weld Carriage System
2 Pages
-
Automatic Overlay Welder
2 Pages