TP10AC series 10W 4KVAC Isolation Wide Input AC/DC Converters The rated output power of TP10AC series is 10W,With very low no-load consumption (only 60mW), Low leakage current(only 0.1mA ),ultra-small size, (50.8*25.4*15.3mm) ,isolated voltage up to 4KVAC. Product safe and reliable,Good EMC performance,EMC And meet the safety specifications of IEC/EN61000-4,CISPR22/EN55022,UL60950/EN60950/EN60601,etc. Widely used in medical, industrial, office and civil industries, if applied to the bad electromagnetic compatibility must refer to the application circuit Universal input voltage range Low power consumption Low Ripple & Noise AC and DC dual-use High efficiency,high power density, ultra-small size RoHS compliant Wide input voltage: 4:1 Over current protection, Short circuit protection Operating temperature: -40°C to 70 °C SELECTION GUIDE Part Number TP10AC220S03W TP10AC220S05W TP10AC220S09W TP10AC220S12W TP10AC220S15W TP10AC220S24W All specifications typical at TA=25°C, nominal input voltage and rated output current unless otherwise specified Parameter Conditions Voltage range DC Input Voltage range AC Input Input frequency Input Current 115VAC External fuse recommended value 16 30 1A/250V, slow fusing, necessary Units VDC VAC HZ mA mA A A

TP10AC series TEMPERATURE CHARACTERISTICS! Rf radiation immunity (RF) IEC/EN 61000-4-3 EFT IEC/EN 61000-4-4 level 4 4kV ( Note: see application circuit for details ) Surge IEC/EN 61000-4-5 level 4 2kV ( Note: see application circuit for details ) l.The above data, except for special instructions, are measured at TA = 25"C, humidity <75%, input nominal voltage 230Vac and 2.Ripple and noise are measured according to the application circuit of this manual, using a 300mm twisted pair and in the case of a bandwidth of 20MHz 3.The parts in the system is considered as a component, need to combine...

1. The output filter capacitance C4 is the electrolytic capacitor. It is recommended to use the high frequency low resistance electrolytic capacitance, the capacity and the current of the flow. Please refer to the technical specifications provided by the manufacturers. Capacitance pressure reduction is greater than 80%. The C5 is to remove the high frequency noise. D1 is recommended for the TVS tube to protect the rear circuit (when the module is abnormal). 2. The dashed box is an EMC filter that is accessible for higher EMC requirements, which can be omitted while general applications 3.We has...