AC/DC Converter UA10-220XXXP2 Series Typical Features ♦Wide input voltage range:85-265Vac/120-380Vdc ♦Typical transfer efficiency 84% ♦ Over current / Short circuit /Over temperature protection, Self-recovery ♦ Input and output highly isolated 4000Vac UA10-220XXXP2 Series— a compact size, high efficient power converter offered by Aipu. It features universal input voltage range, DC and AC dual-use, low ripple, low temperature rise, low power consumption, high efficiency, high reliability, safer isolation, safe and reliable, with good EMC performance, meet IEC/EN61000-4, CISPR22/EN55022, UL60950, EN60950 standard. It widely used in industrial, office and civil applications. For harsh EMC environment, the application circuit in the datasheet is strongly recommended. XX XX-XX X XX X X X — (§)suffix -(?) Case Material -©Packing Code -© Output Voltage -@ Output Ways -© Input Voltage -(D Output Power -© Product Series Remark: Due to space limitations, above is only a part of our product list, please contact our sales team for more items. http://www.aipulnion.com__E-mail: [email protected] TEL: 86-20-84206763 FAX: 86-20-84206762 HOT-LINE: 400-811-8032 Page 1 of 5

Technical Parameters Test Condition: Unless otherwise specified, data in the datasheet should be tested under the conditions of inputting nominal voltage, pure resistance rated load and Ta=25°C .1 http://Www.aipulnion.com E-mail: [email protected] TEL: 86-20-84206763 FAX: 86-20-84206762 HOT-LINE: 400-811-8032 Page 2 of 5

Relative Humidity Case Material Plastic case Isolation Voltage Class of Case Material Packing Code Note: If the definition of pin is not in accordance with the model selection manual, please refer to the label on actual item. E-mail: [email protected]

Ripple& Noise Test: (Twisted Pair Method 20MHZ bandwidth) Test Method: (1) 12# twisted pair to connect, Oscilloscope bandwidth set as 20MHz, 100M bandwidth probe, terminated with 0.1uF polypropylene capacitor and 47uF high frequency low resistance electrolytic capacitor in parallel, oscilloscope set as Sample pattern. (2) Input terminal connect to power supply, output terminal connect to electronic load through jig plate, Use 30cm±2 cm sampling line, Power line selected from corresponding diameter wire with insulation according to the flow of output current. Case Temperature VS Output Load Curve...

1. FUSE: necessary, recommend specification 2A/300V, slow fusing. 2. NTC is therimstors, recommend model:5D-9, to protect converter from damage when lightning surge. 3. MOV is voltage dependent resistor, recommend model: 14D471K, to protect converter from damage when lightning surge. 4.For customer's normal application use Photo 1 recommended circuit, If has higher EMC request, recommended to use Photo 2 recommended circuit. The specifications for Photo 2 circuit are as below: 1) R: metal film resistor, 510KQ/3W; 4) LCM: common mode inductor, 10mH-30mH; 5) MOV: voltage dependent resistor, 14D471K....