Catalogs >
Guangzhou Aipu Electron Technology Co.,Ltd >
NN2-XXXXXH6 Series

NN2-XXXXXH6 Series
5Pages

Catalog excerpts

DC-DC Converter NN2-XXXXXH6 Series fISOVA : \900y7 »i400i» Typical Features ♦ Fixed input voltage, isolated & unregulated output, 2W ♦ Transfer efficiency up to 80% ♦ Miniature SIP package ♦ No external component required ♦ Isolation voltage: 6000VDC ♦ Operating temperature range: -40°C~+85°C ♦ Plastic case, meet UL94-V0 standard Test Condition: Unless otherwise specified, data in the datasheet should be tested under the conditions of inputting nominal voltage, pure resistance rated load and Ta=25C. Product Named Method: - (7)lsolation voltage 6KVdc - (6)19.5*9.8*12.5mm plastic packing - (o/Output voitage:5V - (T)S:single output; D:dual output - (3)Nominal input voltage 5V - (2)0utput power 2W - (T)±10% fixed input voltage, unregulated output series Output Specifications Other input Continuous, self-recovery Output Short Circuit Protection ® Note:® Ripple and noise are measured by twisted pair method. ® There are a small portion can only be guaranteed to be within 5 seconds. Switching Frequency http://www.aipulnion.com E-mail: market@aipu-elec.com TEL: 86-20-84206763 FAX: 86-20-84206762 HOT-LINE: 400-811-8032 Page 1 o

Open the catalog to page 1

http://www.aipulnion.com E-mail: market@aipu-elec.com TEL: 86-20-84206763 FAX: 86-20-84206762 HOT-LINE: 400-811-8032 Page 2 of

Open the catalog to page 2

Note: 1.“ ” is model under developing; 2. To ensure the module work efficiently and reliably, during the operation, the min. output load should be no less than 10% of the rated load. If the actual power is too low, please connect a resister to the output terminal in parallel, with a recommenced resistance which is 10% of the rated power. 3. The capacitive loads of positive and negative outputs are the same. Temperature Curve Temperature Derating Curve 温度降额曲线图 100% 输出功率百分比 Output Power Output Power Percentage Packing Dimension, Pin Function, Recommended PCB layout Side view Printing side...

Open the catalog to page 3

1. Output load request a. To ensure the module work efficiently and reliably, the min. output load should be no less than 10% of the nominal load; If the actual output power is indeed low, please connect a resister to the output terminal in parallel, with a recommended resistance which is 10% of the rated power. b. The maximum capacitive load is tested under nominal input full load, and cannot exceed the maximum capacitive load of output when using, otherwise it will make it difficult to startup and damage the product. 2. Recommended Circuit In order to ensure the ripple and noise of input...

Open the catalog to page 4

4.Output regulated voltage and over voltage protection circuit The simplest device to protect output regulated voltage, over voltage and over current is, to cascade a linear regulator with overheat protection at input or output side, and connect a filter capacitor net(see picture below), filter capacitance recommended value see table 1, linear regulator is chosen according to the actual operating voltage and current needed, or choose our NW series product. Single Output Positive Negative Dual Output Note: 1.This product cannot be used in parallel, and do not support hot-plug; 2. If the...

Open the catalog to page 5

NN2-XXXXXH6 Series 5Pages

Catalog excerpts

All Guangzhou Aipu Electron Technology Co. catalogs and technical brochures

NN2-XXXXXH6 Series
5Pages