Catalog excerpts
For VRLA & Conventional type Motorcycle batteries AUTOMATIC BATTERY CHARGER (Applied Battery type: 12V ■ 2~32Ah/10HR) This battery charger has the following advantages when compared with normal charger (Semi-CV type) and is suitable for both VRLA & Conventional type lead acid motorcycle batteries. 1. Capability to charge deeply discharged batteries Deeply discharged batteries can be recharged using the recovery-charging mode. 2. Determination if battery can be recovered Determines if the battery can be recovered after 30 min. as indicated by LED. 3. Selectable output current Charging will stop automatically after 12 hours maximum. ® Reverse connection and Short circuit ® Spark prevention when connecting charging clips (3) Automatic shut-off when charging clip is disconnected ® Over charge-high current protection (Output) © Reverse current prevention (3.0mA or less) ® Thermally protected transformer prevents overheating >K1. Use the Normal Mode for small batteries (less than 5Ah batteries). 2. For a new battery, add electrolyte and charge for 2 hours in Normal Mode. If the aluminum sealing tape has been removed and/or the battery is more than 2 years old, charge until charger stops automatically. (Note: Specification shown on this leaflet may change time to time without notice)
Open the catalog to page 1All GS Yuasa catalogs and technical brochures
-
Standard Series1 Pages
-
Traction Batteries8 Pages
-
MB-20231 Pages
-
MB-20201 Pages
-
KE series Catalog2 Pages
-
eNiTIME1 Pages
-
CS,HS,SS,PS SERIES12 Pages
-
YUMICRON®4 Pages
-
SNS Series2 Pages
-
PWL Series2 Pages
-
Portalac Series8 Pages
-
UXF Series2 Pages
-
UXH Series2 Pages
-
SE-102 (10A single output)1 Pages
-
Automotive Batteries1 Pages
-
NP Series (NP, NPH)2 Pages
