MID CAPACITY AFTERCOOLERS
2Pages

A SMOOTH ABRASIVE FLOW with dry compressed air aftercooler series To enable trouble-free blasting the compressed air has to be as dry as possible. Gritco’s range of aftercoolers is designed to get the best possible compressed air, for small, mid-sized or large blasting systems To prevent blast pot blockages, secure a smooth, continuous abrasive flow with lesser breakdowns, wear and maintenance, compressed air needs to be cooled down (approximately at 9°C above ambient temperature). Because of this drop in temperature, water condenses and forms drops. These drops are removed by the aftercooler’s centrifugal separator. For even better clean air-results, optional compressed air filters can be fitted to remove oil and other containments. The aftercooler is fitted with a pneumatic motor for easy everywhere use. For stationary use or compressed air savings an electric motor in 240V or 400V is available. Connection to the compressor’s battery is possible with the 12V DC motor for the smaller models. KEEP IT COOL, CLEAN AND DRY Centrifugal separator Powerful benefits • Easy (re)moving and installation • Quick setup in less than a minute • Easy to use and accessible drainage system • Optional automatic drainage Better blasting value because of 80 - 85% • rouble-free blasting production T moist extraction • ominal capacity model range of 1 or 30 m3/min N • inimal pressure drops through large pipework M • est performance at low energy costs because of B optimal fan-design • ide choice of (optional) oil- and containment filters W Quality includes with copper tubes • igh quality heat exchanger H and aluminum fins • rid protected cooling fins G • urable powder coated finish D economics Better blasting production because of • est possible blasting B trouble-free performance with less stops • aving on abrasive use by better metering S possibilities with a smooth continuous abrasive flow • void costly, poor blasting results caused by wet A compressed air Optional compressed air filters

aftercooler series 1. High efficiency separator eliminates moisture from the compressed air. Optional filters can remove oil and other containments to get 100% clean compressed air 2. Automatic drain (optional) 3. Best performance at low energy costs because of optimal fan-design 4. Minimal pressure drops from 1 up to 30m3/min capacity through heat exchanger’s matching pipework with copper tubes and aluminum fins 5. Pneumatic or electric motor in 240V, 400V or 12 V DC 6. Compressed air treatment for efficient RPM and oiling of the pneumatic motor 7. Wide choice in (transport) frame- and...